- Out-of-Stock

Very small and super-light lithium-ion battery. Thanks to the new Li-Ion chemistry, a very good ratio of the battery's capacity to its mass was obtained. The battery has leads in the form of two wires terminated with a JST-PH connector. The battery has built-in protection against overvoltages, too high power consumption and against too low discharge.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Development board with microcontroller from the Freescale KINETIS L family (Cortex-M0+) and MEMS 7DoF sensors.
No product available!
No product available!
SIM7600CE 4G HAT is a module that extends the capabilities of Raspberry Pi for communication via GSM / GPRS cellular networks based on Simcom's SIM7600CE system. It has support for 4G / 3G / 2G / GSM / GPRS / GNSS. Waveshare SIM7600CE 4G HAT
No product available!
No product available!
Module with a water level sensor with a measuring range of up to 10 cm. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020635
No product available!
No product available!
No product available!
Introduction to Digital Design. Block Diagram / Verilog Examples; Richard E. Haskell & Darrin M. Hanna
No product available!
No product available!
White case for the NanoPi NEO3 minicomputer. It allows easy access to the Ethernet connector, USB, microSD cards and the power connector. FriendlyELEC Case for NEO3
No product available!
Battery: Li-Ion; 3.7V; 1000mAh; Outputs: wires with 2-pin JST-PH connector; 50.8 mm x 33.5 x 5.9 mm. PRT-13813