Category: RETIRED PRODUCTS

Comes with a 6"x6" (152mm x 152mm) square of Pyralux. It\'s ED-Y type copper at 35um (1 oz/ft2) and has a polymide of 25um (1 mil). The thick copper layer means it can carry a lot of current, and its trivial to solder to it. Adafruit 1894

Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 25mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 9 x 9 x 4mm

The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs

Kit: MAXimator, MAXimator Expander, ZL32PRG - USB Blaster PRO

Power Supply 2.5A 5.1V for Raspberry Pi 3 model B - STONTRONICS T5875DV

MYD-JA5D44 Development Board is a complete educational platform. Its heart is the MYIR MYC-JA5D44 module, which was equipped with the Atmel SAMA5D44 processor based on Cortex-A5 cores. The processor can work at a maximum frequency of 600 MHz. Min. RS232, RS485 connectors, HDMI connector, 3.5 mm Jack Audio inputs, microSD memory card slot, 10/100 Mbps Ethernet slot and many more.

The Raspberry Pi GPIO Triple Expansion Board converts the single GPIO headers on your Raspberry Pi into three parts. DFR0385

Flex Cable for Raspberry Pi Camera - 300mm / 12". Adafruit 1648

Patchcord UTP 5E Ethernet cable with a length of 50 cm - gray, with 2xRJ45 connectors

Pre-installed Ubuntu 14.04 or latest version. eMMC Version 5.0 interface or higher version from Samsung.
JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode

Patchcord UTP 5E Ethernet cable with a length of 50 cm - blue, with 2xRJ45 connectors

Patchcord UTP 5E Ethernet cable with a length of 1.5 m - black, with 2xRJ45 connectors

Patchcord UTP 5E Ethernet cable with a length of 3 m - black, with 2xRJ45 connectors

Patchcord UTP 5E Ethernet cable with a length of 5 m - blue, with 2xRJ45 connectors

Patchcord UTP 5E Ethernet cable with a length of 5 m - gray, with 2xRJ45 connectors

The board gives the possibility to significantly extend the functionality of the STM32F407G-DISC1 development kit. The plate contains, among others memory card slot (microSD), Ethernet socket and connectors that can be used to attach SMT32F4DIS modules to the board

Camera board for the STM32F407G-DISC1 set. It allows you to capture an image with a resolution of 1280 x 1024 pixels (1.3MP). The set includes a flexible cable that allows the camera to be connected to the STM32F4DIS-BB expansion board

The MyoWare Muscle Sensor is now designed to be wearable allowing you to attach biomedical sensor pads directly to the board itself. DEV-13687

5V / 3.1A eXtreme power supply with microUSB plug for all Raspberry Pi computers (including Pi 3 model B and Pi 3 model B +)

3.2D soldering tip, flat screwdriver 5.5mm in diameter, for WEP 926 soldering station