Seeeduino Crypto - board with ATmega4809 microcontroller and cryptographic chip

A miniature development board with ATtiny85 microcontroller, on which 6 I / O pins were derived. The module is supported by Arduino IDE. modATT85

Board compatible with Arduino, based on ATmega328P. Equipped with an area with prototype holes, a breadboard, 12 LEDs, a button and a buzzer. Cytron MAKER-UNO-X

Board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface

Microcontroller board based on Leaf Maple, STM32F103RB, USB, RoHS

Development kit with ATSAMD21G18A microcontroller. It has 14 GPIO connectors, including 11 digital and analog pins, 10 PWM, DAC, I2C, UART, SPI, SWD. Compatible with Arduino. Seeed Studio 102010388

Development board with ATmega328P microcontroller compatible with Arduino Uno Rev3. Waveshare R3 PLUS

The board is equipped with ATSAMD21 microcontroller with ARM Cortex-M0 core. It has connectors and dimensions compatible with the Arduino Uno Rev3. HW-819

Development board equipped with RP2040 microcontroller, RGB LED diodes, buzzer and Qwiic/STEMMA QT connectors. Pin spacing compatible with Arduino Nano. Cytron MAKER-NANO-RP2040

Development board with ATmega328P microcontroller equipped with 14 I/O lines, 6 PWM channels, 6 analog inputs and FT231X chip. Compatible with Arduino UNO Rev3. Cytron CT-UNO-SE

A small development kit with a SAMD21 ARM Cortex M0 + microcontroller. There are 14 GPIO connectors on the board, including 11 digital and analog pins, 10 PWM, DAC, I2C, UART, SPI, SWD. Compatible with Arduino. Seeed Studio 102010328

Development board with SAMD21G18 microcontroller. It offers operating frequency up to 48 MHz, 256kB FLASH memory and 32kB SRAM.

The board is compatible with Arduino, based on the ATmega328P microcontroller from the AVR family, 14 I/O lines, 6 PWM channels, 6 analog inputs are available to the user. The CH340G chip communicates via a USB interface. In addition, it has 12 LEDs, a programmable button and a embedded buzzer. Cytron Uno Maker

Board compatible with Arduino Nano. It is based on the ATmega328P microcontroller with 32 KB Flash, 2 KB SRAM and 1 KB EEPROM. It has 12 LEDs, a buzzer and a user button. Cytron Maker Nano

Board with ATmega2560 microcontroller (256 kB Flash, 8 kB RAM, 4 kB EEPROM) clocked at 16 MHz. USB-UART converter based on the ATmega16u2 chip. The user has at his disposal, among others: 54 I/O lines, 14 PWM channels, 16 analog inputs.

Virtual keyboard module in the form of a small flash drive. It allows you to simulate the keyboard after uploading the appropriate software and pressing a combination of buttons on the computer.

Board compatible with Arduino, equipped with the ATmega32U4 microcontroller