Best sellers

Dispensing needle for precise application of glue, flux with an internal diameter of 0.51mm and an external diameter of 0.8mm. Set of 5 pcs

Janusz Kwaśniewski

The 15 cm long tape allows you to connect the camera to the Raspberry Pi Zero series. Waveshare RPi Zero V1.3 Camera Cable 15cm

Female terminal block, angled, 6-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-6P

7.5A car fuse is a key protection element for vehicle electronic systems, supplied in a set of 10, small in size and easy to replace

T-Cobbler adapter enabling connection of GPIO Raspberry Pi A +, B +, Pi 2, Pi 3, Pi 4 and Pi 5 lines to the breadboard (2.54 mm). Adapter assembled, included connecting tape

The KAmod BlackPill 401 is an evaluation board with an STM32F401CCU microcontroller, featuring USB-C with ESD protection and a modified power circuit. With a pre-installed bootloader, it supports Arduino IDE, offering 32 GPIOs and versatile programming capabilities

L7805CV, +5V voltage regulator, 1.5A, TO220, STM, RoHS

Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament

Neodymium rectangular magnet with dimensions of 15x5mm a and a height of 3 mm. Set of 10 pcs

Universal oscilloscope probe with BNC connector. It has a voltage divider of 10:1 and offers a frequency response of 100 MHz. It allows measurements with a maximum voltage of up to 600 V. P6100

Low Power, Precision Analog microcontroller with Dual Sigma-Delta ADCs, ARM Cortex-M3, QFN48, Analog Devices, RoHS

50MHz SMD oscillator, 3.5mm x 2.5mm, RoHS

LED 5 mm Red water clear, angle 10 degrees; light intensity 10,000 mcd (20mA); df 635nm

Industrial USB TO TTL (D) Serial Cable, Original FT232RNL Chip, Multi Protection Circuits, Multi Systems Support, With Separated 4pin Header + SH1.0 3PIN Connector, Suitable For Raspberry Pi 5 Serial Port Debugging. USB TO TTL (D)

5 mm Green Diffused LED, 60 degree angle; light intensity 80 mcd (20mA) (2.25V); df 568nm

ARM®-based 32-bit MCU, 128 KB Flash, CAN, 12 timers, ADC, DAC & comm. interfaces, 2.0 - 3.6V, LQFP48, STM, RoHS

RJ12 6-Pin PH 10-Pin IDC Adapter for PIC Microcontrollers Programming