Best sellers
There are 16464 products.
PP (Polipropylen) filament in Gray, 1.75 mm in diameter. 0.75 kg of filament is wound on a spool. Fiberlogy Easy PP Gray
PP (Polipropylen) filament in Light green, 1.75 mm in diameter. 0.75 kg of filament is wound on a spool. Fiberlogy Easy PP Light green
A set for building a walking robot. The chassis is equipped with four servos, a controller and an STM32F030 microcontroller. M5Stack U086
Ammeter module designed for M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. M5Stack U086
Lipo battery with a capacity of 750 mAh for the M5Stack sets. Modules can be connected in parallel and stacked. M5Stack M002
ATOM Lite development kit complete with DRV8825 stepper motor driver module. M5Stack ATOM STEPMOTOR
SoM Raspberry Pi CM4 with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5 GHz, 4 GB LPDDR4 RAM and 32 GB eMMC. Raspberry Pi CM4004032
1 MPx camera module with OV9281 sensor that works with all versions of the Raspberry Pi. Equipped with a shutter and an IR filter, it is characterized by good sensitivity. Waveshare OV9281-120 Camera
Easy PLA filament in Red Orange, 1.75 mm in diameter. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PLA Red Orange
Easy PLA filament in True Blue, 1.75 mm in diameter. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PLA True Blue
The board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers at 20W each. Adafruit 1752
Educational kit for learning TinyML. It consists of the Wio Terminal module, Grove sensors and the course. Seeed Studio 114992774
Kit for building robots powered by a solar panel. The set of parts allows you to build 13 versions of robots that move under the influence of sunlight
A module with a high precision temperature sensor based on the STS35 system. It allows measurement with an accuracy of ±0.1° C and communicates via the I2C interface. DFRobot SEN0434
Spring-loaded test needle for connecting and testing modules without soldering
4-digit LED watch in the form of a kit for self-assembly. Equipped with a light sensor, thermistor and buzzer, it is controlled by two buttons
LCD panel with the possibility of controlling its transparency. Can block up to about 95% of incident light. Adafruit 3330
Module with GPS PA1616D receiver based on the MTK3333 system. It is equipped with a USB type C connector and a USB-UART converter. Adafruit 4279
Module with WiFi Espressif ESP32-S2. It has 4MB Flash, 2MB PSRAM, and integrates a BME280 sensor, LiPo charging circuit, and RGB LED. Equipped with a STEMMA QT connector. Adafruit 5303
Module with an IO pin expander based on the TCA9534 system. It allows you to add 8 GPIO pins to an I2C-controlled project. SparkFun DEV-17047