ZeroPi is a FriendlyELEC single board computer with Allwinner H3 and...
Module with the MCP9600 amplifier designed to work with a K-type...
Heat shrink tube for electrical and mechanical insulation, diameter...
The MIMXRT1062DVL6A Processor Evaluation Kit, which runs up to 600 MHz,...
RTL8370N-VB-CG, high-performance 8-port Gigabit Ethernet switch, LQFP128
LT8911EXB, MIPI DSI/CSI Bridge to eDP, QFN48
Capacitive proximity sensor with PNP NO output. It can detect the...
A4952ELYTR-T, Full-Bridge DMOS PWM Motor Drivers, 40V, 2A, MSOP-10
These aluminum gearmotor brackets let you securely mount our larger Pololu plastic gearmotors (228:1 offset, 120:1 offset, 200:1 90-degree, and 120:1 90-degree) to your project. These brackets are sold in pairs, and each bracket comes with two 1″ long and two 0.75″ long #2-56 screws for securing different size motors.
These light-weight brackets (approximately 2 g each) are specifically designed for our larger Pololu plastic gearmotors (228:1 offset, 120:1 offset, 200:1 90-degree, and 120:1 90-degree). Each bracket features two mounting holes and one mounting slot intended for #4-size screws (not included). We also offer an extended version of this bracket that allows for even more mounting options and might work better for particular applications.
A total of four 1″ long #2-56 screws, for use with the 228:1 offset and 120:1 offset plastic gearmotors, and four 0.75″ long #2-56 screws, for use with the 200:1 90-degree and 120:1 90-degree plastic gearmotors, are included. Two #2-56 hex nuts are also included for each bracket. Only two screws are used to mount a motor to each bracket, as shown in the pictures below:
These brackets also work with the Solarbotics plastic gearmotors (GM2, GM3, GM8, and GM9), although different length mounting screws might be required.
The following drawing shows the bracket dimensions in mm.
Mechanical drawing for the Pololu stamped aluminum L-bracket for plastic gearmotors. Units are mm over [inches].