New products
New products
Available
Available
€17.60
Delivery date unknown
€14.40
Delivery date unknown
Available
€5.16
24h
Available
€4.83
24h
Available
Available
Available
Available
€17.60
Delivery date unknown
€14.40
Delivery date unknown
Available
€5.16
24h
Available
€4.83
24h
Available
Available
Analog MEMS Microphone Breakout - module with an analog microphone SPH8878LR5H-1
ID: 1178841
5906623418220
€7.64
Tax included
€6.22 tax excl.
A module with a MEMS microphone and an amplifier that will allow you to detect a voice, a clap or a door slam. The board has an analog output. SparkFun BOB-19389
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
The module with the analog microphone MEMS SPH8878LR5H-1 and the operational amplifier, which allows the direct connection of the system to the ADC converter on the microcontroller. The microphone used is omni-directional, which means that it is good at picking up sound sources from all directions. The microphone port is located on the bottom of the board, so keep this in mind when installing the module in the project. The sensor will allow you to add sound to the application, it will allow you to detect voice, clap or slam the door. Full documentation with examples of use is available on the product page.
Features
- Supply voltage: 2.3 to 3.6 V
- Average current consumption: 265µA
- Frequency range: 7Hz to 36kHz
- Signal to noise ratio: 66dBV / Pa
- Sensitivity: ~ 44dBV / Pa (unidirectional mode)
- -3dB Roll Off at 7Hz / + 3dB at 36kHz
- Acoustic overload point: 134dB SPL
- OPA344 provides an output impedance of 600 Ω
1178841
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Pin header goldpin black 1x40 pins. Straight connector for through-hole assembly. 2.54mm pitch.
€0.30 24hAvailable quantity: 5218 AvailableA set of 40 pieces of female-female connecting cables in various colors, 10 cm long
€0.97 24hAvailable quantity: 411 AvailableA set of 40 pcs of male-female connecting cables in various colors, 10 cm long
€1.01 24hAvailable quantity: 293 AvailableA set of 40 pcs of male-male connecting cables in various colors, 10 cm long
€1.41 24hAvailable quantity: 25 Available
Other products in the same category (16)
MEMS SPU0414HR5H-SB analog microphone module. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020852
€10.11 24hAvailable quantity: 1 AvailableModule with electret microphone and LM393 amplifier that will allow you to detect voice, clap, slam doors and other sounds using analog or digital output
€1.01 24hAvailable quantity: 10 AvailableA module with an electret microphone and amplifier that will allow you to detect voice, clap, slam doors and other sounds using an analog or digital output. SparkFun SEN-14262
€14.92 3 weeks No product available!
KAmodMIC_ELECTRET is a module with microphone KPCM6B type. Thanks to embedded amplifier with hundredfold amplification of signal, output voltage can be measurement in microcontroller with using e.g. ADC converter.
€2.53 24hAvailable quantity: 168 AvailableAudio module that allows you to play sounds from a USB memory, microSD card, via Bluetooth or FM radio. It is equipped with a microphone, 3.5 mm audio jack and control buttons
€6.66 24hAvailable quantity: 1 AvailableA module with an electret microphone, amplifier and ADC converter dedicated to micro: bit. It communicates via the I2C interface. SparkFun SEN-15289
€9.79 24hAvailable quantity: 2 AvailableBOB-09868 - Breakout Board for ADMP401 MEMS Microphone, SparkFun
€17.63 3 weeks No product available!
Gravity: Analog Sound Sensor is a sound sensor with Gravity analogue output. The module can be supplied with 3.3 ... 5V voltage. DFRobot DFR0034
€5.16 24hAvailable quantity: 5 AvailableA module with an electret microphone and MAX9812 amplifier, which will allow you to detect a voice, a clap or a door slam. Has an analog output
€7.18 24hAvailable quantity: 6 AvailableA module with an electret microphone and an amplifier that will allow you to detect a voice, a clap or a door slam using the analog output
€2.93 24hAvailable quantity: 11 AvailableA set with a vibration generator designed to transfer sounds through the human skeleton to the auditory center. DFRobot KIT0126
€35.40 24hAvailable quantity: 1 AvailableThis small breakout board couples an Electret microphone (100Hz–10kHz) with a 60x mic preamplifier to amplify the sounds of voice, claps, door knocks or any sounds loud enough to be picked up by a microcontroller’s analog-to-digital converter. Each breakout comes fully assembled and works from 2.7V up to 5.5V. BOB-12758
€10.51 24hAvailable quantity: 2 AvailableModule with PDM microphone. It allows you to receive a sound signal and send it using PDM modulation. Adafruit 3492
€6.59 24hAvailable quantity: 15 AvailableModule with a sound sensor based on an electret microphone and LM358 amplifier. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020023
€7.17 24hAvailable quantity: 3 AvailableAudio module with two microphones and display designed to work with the Raspberry Pi. Pimoroni PIM524
€35.43 4 weeks No product available!
The VM-CLAP1 Hand Clap Sensor from Verbal Machines is a low-power, microprocessor-based audio sensor that can detect hand claps or finger snaps while ignoring background noises such as human speech or music. Pololu 2580
€26.55 24hAvailable quantity: 1 Available
A module with a MEMS microphone and an amplifier that will allow you to detect a voice, a clap or a door slam. The board has an analog output. SparkFun BOB-19389