MH-M28 - Bluetooth 4.2 audio receiver

Bluetooth audio receiver module with microphone in set with 3.5 mm Jack adapter. It enables wireless transmission of sounds. It is equipped with a 3.5 mm audio jack, microUSB socket and a control button

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from a mass memory (flash drive), from a computer via USB or from a microSD card

Bluetooth 4.2 audio receiver with 5W stereo amplifier per channel. It allows you to play files via Bluetooth interface and supports WAV, APE, MP3 and FLAC formats. MH-M38

Audio module with DAC, stereo amplifier and display, designed to work with the Raspberry Pi. Pimoroni PIM484

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94

Audio receiver with Bluetooth 4.2 module. It is powered by a microUSB connector or a battery and is equipped with a charging circuit

Adafruit 2217

Bluetooth audio receiver module in the set with a 3.5 mm Jack adapter. It enables wireless transmission of sounds. It is equipped with a 3.5 mm audio jack, microUSB socket and control buttons

The audio module with the PCM5100A DAC converter is designed to work with the Raspberry Pi. Pimoroni PIM542

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It is equipped with an insulated converter that enables power supply with 12 V voltage

An audio module with a DAC converter designed to work with the Raspberry Pi. Supports I2S/DSD/Coaxial input, Analog/Coaxial/Optical/I2S output, and has 384K/32Bit decoding function. DFRobot DFR0941

WIG-12897WAV file player module controlled by UART interface or switching inputs. It is based on a 2 W audio amplifier. The board has a 3.5 mm audio output and a speaker connector. The files are played from the microSD card. SparkFun DEV-13660

Module with a multi-channel WAV player. It allows you to mix 32 mono or 18 stereo tracks with the ability to connect to any MIDI controller. It has 8 mono or 4 stereo audio outputs. SparkFun WIG-18159

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21250