MAX31855PMB1

The Pmod DHB1 uses DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. 410-259

High-speed communication module powered by ADM582E. By communicating with the device via UART, users can take advantage of the RS485 communication protocol with speeds up to 16 Mbps. 410-310

Accessory board designed to provide students a cost-effective, portable, and engaging platform for teaching electronics. With a myDAQ / myRIO, NI Multisim, and a myDigital, you\'ll have everything needed to allow students to design, construct, test basic analog and digital designs. 6002-410-006

The extension cable lets you locate your Pmod away from its host board, and the included male gender changer can provide extra connectivity to both system and prototyping boards. 240-021-1

Provides a 300 tie breadboard and 50 tie bus bar on an expansion card compatible with the NI myRIO Expansion Port (MXP). 210-283

Digital logic level shifter ideal for users who want to supply logic signals following a 3.3V CMOS standard but have an alternate logic level output that is used for other applications, such as JTAG programming. 410-320

Graphical display, users may show off graphs, full-color pictures, text, and anything else they want to see by communicating with it through SPI. Digilent 410-323

The Digilent Pmod NAV uses the LSM9DS1 3-axis accelerometer, 3-axis gyroscope, 3-axis magnetometer, plus the LPS25HB digital barometer to provide users with 10-DOF functionality. Digilent 410-326

 relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080, you can determine the relative humidity of the environment with up to 14 bits of resolution. Digilent 410-347

With an on board Microchip PIC16 MCU, two-axis joystick on a center button, a trigger button, and a programmable RGB LED capable of 24-bit color, the Pmod JSTK2 is ideally suited for Digilent microcontroller or FPGA-based projects that require proportional control from the user, such as robotic applications. Digilent 410-330

The Pmod SF3 provides users with 32 MB of non-volatile memory through the use of Micron\'s NOR Flash memory (N25Q256A). By using the SPI protocol, users can both write to and read from the flash memory. Digilent 410-340

Pmod VGA is a module in the VGA video output for development boards equipped with a Pmod connector. With its help, it is possible to display the image on monitors that have a VGA input. Digilent 410-345

Pmod MTDS is a module with a 2.8-inch LCD display. It has a resolution of 320x240 pixels. It has touch support (capacitive, 2 point). Digilent 410-341

Pmod SSR is a module with a semiconductor relay. One GPIO port is required for control, the relay is suitable for operation with up to 48 V, it can be used for devices that draw current up to 6 A. Digilent 410-342

PmodCMPS2 is a module with a digital magnetometer based on the Memsic MMC34160PJ system. It has a resolution of 0.5 mG (within ± 16) and accuracy up to 1 °. For communication with the module, an I2C interface is provided on the 6-pin Pmod connector. Digilent 410-355

Pcam 5C: 5 MP Fixed Focus Color Camera Module with Omnivision OV5640 5 megapixel (MP) color image sensor which includes various internal processing functions, incl. automatic white balance, automatic black level calibration, and controls for adjusting saturation, hue, gamma and sharpness. Digilent 410-358