15EDGRC-3.81-8P - Male terminal block, angled, 8-pin, pitch 3.81 mm

Robot controller dedicated to Totem sets. It is based on the ESP32 chip (WiFi and Bluetooth module), equipped with a DC motor and servo driver, RGB diodes and an IMU sensor. Totem TE-X4-KIT1

Thermally conductive tape used as a replacement for thermally conductive paste. They are very flexible and characterized by high compressibility. AG Termopasty ART.AGT-161

Li-Po battery with a rated voltage of 3.7 V and a capacity of 1350 mAh, equipped with a PCM protection and a 1.5 JST-ZH connector. Akyga LP503758

Module with a 3-axis MMA8452Q accelerometer. The system has a configurable measurement scale of ±2g/±4g/±8g. It is supplied with the voltage from 1.95 to 3.3 V and communicates via the I2C interface. SparkFun SEN-12756

External enclosure designed to protect, transfer and store data on 2.5” HDD and SSD drives with SATA interface. UGO UKZ-1531

128 GB Hynix SSD. It is equipped with NVMe PCIe 3.0 interface with M.2 B&M Key connector. Hynix HFM128GDHTNG-8310A

Samsung 980 SSD 250 GB. It is equipped with NVMe PCIe 3.0 x4 interface with M.2 M Key connector. Samsung MZ-V8V250BW

External case designed to protect, transfer and store data on M.2 SSD drives with SATA interface. GEMBIRD EE2280-U3C-01

Module with e-Paper display with a diagonal of 2.13" and a resolution of 250x122 px with WiFi communication and Bluetooth 4.2. Waveshare 2.13inch e-Paper Cloud Module

LoRa module based on ESP32-WROOM-32E with WiFi and Bluetooth communication and LoRa RFM95W modem. There are ESP32 pins and a Qwiic connector on the board. SparkFun WRL-18074

A module with a MEMS microphone and an amplifier that will allow you to detect a voice, a clap or a door slam. The board has an analog output. SparkFun BOB-18011

Base board for the SpaceSOM-8Mplus family of modules. Creates a complete development platform similar to the SBC. SoMLabs SpaceCB-8Mplus-ADV v.1.1

50 W soldering iron for Bakon BK950D station. Works with soldering tips from the T13 series

HAT expansion module with SATA interface designed for Raspberry Pi 4 model B. It allows you to connect to a minicomputer mass storage in the form of 2.5" HDDs and SSDs with SATA interface

HAT type power supply module with cooling fan designed for Raspberry Pi 4 model B. Provides flexible power supply to the minicomputer via DC 5.5x2.5 mm connector, XH2.54 mm connector, microUSB or USB type C connector

Wall charger with USB and USB type C sockets. Supports QC3.0 + PD3.0 fast charging protocol with a maximum current of up to 3 A. USAMS US-CC085