- Out-of-Stock

Raspberry Pi 2 and Pi 1 model B+ Enclosure - Clear
No product available!
The Leonardo ETH is a microcontroller board based on the ATmega32U4 and the new W5500 TCP/IP Embedded Ethernet Controller (datasheet).
No product available!
Minicomputer with Amlogic S922X processor, which integrates the ARM Cortex-A73 quad-core chip and Cortex-A53 dual-core with Mali-G52 GPU and 4GB of RAM. Additional equipment includes: eMMC memory slot, HDMI, microSD card slot and 40-pin GPIO connector. Hardkernel Odroid N2L
No product available!
ROSA3D filament made of PA12 nylon with the addition of carbon fibers. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PA12 + CF15
No product available!
The clamp meter is equipped with a power and harmonic measurement function. It can measure voltage, current, reactive power, power factor and phase angle. Uni-T UT243
No product available!
Camera with CMOS AR0330 sensor with a resolution of 2304x1286 px. It communicates via a parallel interface. ArduCAM U6032
No product available!
No product available!
TRANSOFON - A SYSTEM TO CHANGE THE HEIGHT OF A SOUND - A KIT FOR INDEPENDENT INSTALLATION
No product available!
No product available!
No product available!
5V / 3.1A eXtreme power supply with microUSB plug for all Raspberry Pi computers (including Pi 3 model B and Pi 3 model B +)
No product available!
No product available!
No product available!
No product available!
No product available!
Plastic gear motor 200:1, output shaft at 90°, operating voltage 6 V, current consumption from 0.07 A to 0.8 A, speed 51 RPM and a maximum torque of 7.2 kg*cm. Pololu 1120
No product available!