Arduino Shield - Motor PCB

Graphic LCD 240x128, 144x104mm, LED backlight (WHITE) NEGATIVE BLUE, T6963C controller, character generator

BOILER HEATER CONTROL - PRINTED PLATE

Soldering station 5in1: hotair 100..480 degrees C, soldering tip 75W, power supply 0..15V / 1A, RF signal tester, voltage meter. Included, among others set of nozzles and wires for the power supply

ELECTRONIC HIGROMETER - PRINTED PLATE

Herlihy Maurice, Shavit Nir

LUKOMOMETER - A KIT FOR SELF-ASSEMBLY

RC5 RELAY CARD - PROGRAMMED SYSTEM

QUICK RELEASE NICD BATTERY CHARGER - SELF-MOUNTING KIT

AVT kit for self-assembly of an accurate clock with a 20mm display set by means of GPS. AVT5522 / 1 B

Starter kit with the Altera FPGA system from the MAX10 family, which in addition to the classic, configurable logical resources are equipped with a 12-bit ADC converter, Flash memory for the user and internal configuration memory. The set is equipped with Arduino system connectors and basic peripherals for project testing.

THE LOTTOMAT IS 4 IN 1 - A KIT FOR SELF-ASSEMBLY

Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire

Futaba J Connector Pack, Female