- Out-of-Stock
NGX Technologies mX-LPC1114-S
ID: 187864
mX-LPC1114-S
mX-LPC1114-S
mX-LPC1114-S is a CORTEX-M0 based stamp board for NGX's mbed-Xpresso Baseboard. The LPC1114 microcontroller has 32KB of internal flash and 8KB SRAM. The LPC1114 operate at CPU frequencies of up to 50MHz. In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Programmable WatchDog Timer (WDT). 1 x UART,1 x I2C-bus interfaces Fastmode Plus with a data rate of 1 Mbit/s. 1 x SSP controllers, 8-channel 10-bit ADC, Four general purpose counter/timers with a total of four capture inputs and 13 match outputs. Integrated PMU , power on Reset and up to 42 general purpose I/O pins. GPIO pins can be used as edge and level sensitive interrupt sources.
Following are the salient features of the board:
- Dimensions: 126x35 mm2
- Two layer PCB (FR-4 material)
- On-board Test Led
- 12MHz crystal
- On board debugger.
- No power supply required, powered through USB
187864
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
No product available!
No product available!
No product available!
LCD 4x20, 146x62.5mm, LED backlight (white), NEGATIVE BLUE, enhanced temperature range, RoHS
Delivery date unknown
No product available!
A universal multimeter allows you to measure direct and alternating voltage, direct and alternating current, resistance, capacitance and frequency. Equipped with diode tester, circuit continuity test, automatic circuit breaker and Hold functions. Uni-T UT136B
Retired
No product available!
No product available!
No product available!
No product available!
Dudley Creagh, David Bradley
Delivery date unknown
No product available!
Wires with Pre-crimped Terminals 50-Piece Rainbow Assortment M-F 6"
Retired
No product available!
No product available!
7 pin GPIO ribbon cable (20 cm) for Odroid C4
Retired
No product available!
No product available!
Raspberry Pi 5V / 3A power supply from Kruger & Matz with two cables: USB-microUSB and USB-DC 0.7x2.5x10mm. For all Raspberry Pi computers (including Pi 3 model B and Pi 3 model B +). Made of high quality material. It has protection against overcharging and overvoltage
Retired
No product available!
No product available!
The case has openings for all outputs including the GPIO port making it a great fit for projects that are connected to external hardware.
Retired
No product available!
mX-LPC1114-S