- Out-of-Stock
AVT2280 / 1 A
ID: 193327
CAR ALARM CONTROL PANEL WITH INFRARED REMOTE CONTROL - PRINTED PLATE
CAR ALARM CONTROL PANEL WITH INFRARED GUARD - PRINTED PLATE
Producer: AVT
The system of the alarm control panel activated by an infrared remote control, which prevents the eavesdropping of the signal as it is in the radio remote controls. The control panel has six alarm outputs and two executive elements, ie relays controlling signalers.
The printed circuit board and documentation are included.
A version with a set of independent components is available
The exact description of EdW 5/98
Download
193327
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
Probe for measuring direct and alternating current with a current of up to 30 A. Works in the band up to 100 MHz, it can be connected to the oscilloscope through the UPI connector. It does not require an external power supply. Micsig CP1003
Retired
No product available!
No product available!
No product available!
No product available!
ROSA3D filament made of high-quality polycarbonate with Teflon. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PC+PTFE White
Retired
No product available!
Graphic LCD 128x64, LED backlight (Yellow/Green), enhanced temperature range; replaced A-series, built with COG display, PCB 93x70mm, RoHS
Retired
No product available!
HDMI to CSI-2 bridge module based on TC358840 chip. It has a 22-pin FPC connector with a pitch of 0.5 mm and an audio connector. The input signal is supplied through the HDMI connector. Auvidea 70511
Retired
No product available!
No product available!
No product available!
Premium Jumper Wire 10-Pack F-F 12" Purple
Retired
No product available!
No product available!
Printed circuit board with programmed night lamp controller system with time system. AVT1969 A +
Retired
No product available!
Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 25mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 9 x 9 x 4mm
Retired
No product available!
A module with a microphone for recognizing voice commands. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020312
Retired
No product available!
CAR ALARM CONTROL PANEL WITH INFRARED REMOTE CONTROL - PRINTED PLATE