- Out-of-Stock
AVT1491 B
ID: 193683
2x5W AMPLIFIER - SELF-ASSEMBLY KIT
2x5W AMPLIFIER - SELF-ASSEMBLY KIT
Producer: AVT
A full-value, stereo power amplifier system, powered by a single voltage. The output power is 2x5W. The whole is designed as a module that can be used in hand-made amplification equipment or installed in a factory device, eg in the place of a damaged power amplifier. The system will also work great as an adapter for portable music players. The big range of the supply voltage is a big advantage.
The device is especially recommended on the website (for repairing damaged equipment) and during the construction of own playing devices.
Selected parameters:
- 2x5W output power
- cooperation with 4 or 8 ohm speakers
- 0.4% distortion (for P = 1W and f = 1kHz)
- built-in short-circuit and thermal protection
- soft start system
- standby and mute voltage-controlled modes
- small dimensions of the tile
- power supply - 10-32Vdc
- in the set a printed circuit board, a set of elements and documentation
- A detailed description in EP 9/08
Download
193683
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Adapter board from SODIMM200-2.5 to 2.54mm connectors
Retired
No product available!
The expansion module to support two cameras is designed for Raspberry Pi minicomputers. The board allows you to connect two cameras via CSI connectors to one minicomputer connector. ArduCAM B016601
Retired
No product available!
Evaluation kit with LittleBee GW1N-1 FPGA chip. Offers 1152 LUTs and 864 Flip-Flops (FF). The board has an FPC connector for the display and a USB type C. Sipeed Lichee Tang Nano
Retired
No product available!
Video splitter for connecting one input device to 2 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0002
Retired
No product available!
Video splitter for connecting one input device to 4 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0004
Retired
No product available!
Video splitter for connecting one input device to 8 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0008
Retired
No product available!
Video switch that allows you to connect 5 input devices to one HDMI receiver. The input signal can be selected using a button on the casing or the included remote control. Lanberg SWV-HDMI-0005
Retired
No product available!
A set of 8 knives, including 4 knives with broken blades and 4 special-purpose knives. Vorel 76280
Retired
No product available!
Module with an analog temperature and humidity sensor based on the SHT10 system. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers. DFRobot DFR0066
Retired
No product available!
Module with a CCS811 air quality sensor for measuring the concentration of carbon dioxide (eCO2) and volatile organic compounds (TVOC) in the air. It communicates via the I2C interface (Gravity connector). DFRobot SEN0318
Retired
No product available!
Module with a gesture and touch sensor. It recognizes 7 types of gestures and has 5 touch buttons. It is supplied with a voltage ranging from 3.3 V to 5 V and communicates via UART. DFRobot SEN0285
Retired
No product available!
Module with a 3-axis analog MMA7361 accelerometer. There are 3 Gravity connectors on the board (for each axis). The operating range of the sensor can be configured using a DIP switch. DFRobot DFR0143
Retired
No product available!
Module with a UV ultraviolet light sensor VEML6075. Enables measurement of the level of UVA (350-375 nm) and UVB (315-340 nm) radiation. It communicates via the I2C bus. DFRobot SEN0303
Retired
No product available!
The I2C-GPIO converter module is powered with the voltage of 5 V. It allows you to extend the number of digital pins of the Arduino-compatible board with an additional 16 IO pins. DFRobot DFR0013
Retired
No product available!
KAmodRPI RS485 CAN HAT is a shield for the Raspberry Pi computer that extends its interfaces with RS485 and CAN. Bus signals are led out to goldpin connectors and terminal blocks.
Retired
No product available!
Opening/closing sensor designed for mounting on windows and doors. It is equipped with an RF wireless communication module operating at 433 MHz. Sonoff DW2 - RF
Retired
No product available!
2x5W AMPLIFIER - SELF-ASSEMBLY KIT