- Out-of-Stock
Meter, frequency counter or fmeter - all these names define the device used to measure the frequency. This is undoubtedly one of the basic instruments in the electronics studio. Models with high measuring accuracy are equipped with eight- and ten-digit reading fields. Meanwhile, a meter that has three or four significant digits is often enough. Then, the entire device may have smaller dimensions, which allows it to be easily incorporated into portable equipment. This is the set presented. The meter was built using PIC 16F628. Its structure includes all the functional blocks necessary to measure the frequency. The appropriate program and several additional elements in the SMD technique make the whole system extremely small. Practically, printed circuit boards are added to the display - they are much smaller from it.
The device is particularly recommended for portable devices, where frequency measurement is required
Selected parameters:
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Lithium Polymer rechargeable cell with a Protection circuit. Compatible with ODROID-C0
No product available!
MYIR MYC-JA5D44 is a single-board computer in the form of a card with SO-DIMM 200-pin connector. The SAMA5D44 processor from Atmel, based on Cortex-A5 cores, has been equipped. It can work with a maximum frequency of 600 MHz. It has 512 MB of DDR2 SDRAM, 512 MB of NAND Flash memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector.
No product available!
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
No product available!
No product available!
The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133
No product available!
Printed circuit board with programmed layout for a dual-function acoustic switch. AVT3144 A +
No product available!
Programmed layout for a dual-function acoustic switch. AVT3144 UK
No product available!
A set for self-assembly of a dual-function sound switch. AVT3144 B
No product available!
Printed circuit board and programmed clock system with a 20mm display set by means of GPS. AVT5522 / 1 A +
No product available!
AVT kit for self-assembly of an accurate clock with a 20mm display set by means of GPS. AVT5522 / 1 B
No product available!
Assembled, accurate clock with 20mm display set by means of GPS. AVT5522 / 1 C
No product available!
Printed circuit board and programmed clock system with a 55mm display set by means of GPS. AVT5522 / 2 A +
No product available!
AVT set for self-assembly of the clock with a 55mm display set by means of GPS. AVT552 / 2 B
No product available!
Assembled clock with 55mm display set by means of GPS. AVT5522 / 2 C
No product available!
A set of PCB boards and a programmed layout for building a simple led clock. AVT3132 A +
No product available!
AVT kit for self-assembly of a simple LED clock with a blue display. AVT3132 B
No product available!
FREQUENCY METER - FMETER - PROGRAMMED SYSTEM