Pololu 1597 - 35:1 Metal Gearmotor 15.5Dx30L mm

Gearmotor Dimensions:

This brushed DC gearmotor has a long (0.365" or 9.27 mm), 3 mm-diameter D-shaped metal output shaft that matches our assortment of Pololu wheels and the Solarbotics RW2 rubber wheel. Alternatively, our 3mm universal mounting hub can be used to mount custom wheels and mechanisms to the gearmotor’s output shaft.

The face plate has two mounting holes threaded for M2 screws. We do not currently offer any brackets that work with this motor.

35:1 and 115:1 metal gearmotor 15.5Dx30L mm dimensions (units in mm).

Pololu wheel 32×7mm on a micro metal gearmotor.

Pololu wheel 42×19mm with micro metal gearmotor.

Black Pololu 90×10mm wheel on a Pololu micro metal gearmotor.

These motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.

Selecting the Right Gearmotor

We offer a wide selection of metal gearmotors that offer different combinations of speed and torque. Our metal gearmotor comparison table can help you find the motor that best meets your project’s requirements.

Some of the Pololu metal gearmotors.