- Out-of-Stock
Pololu 1700 - Premium Jumper Wire 50-Piece Rainbow Assortment F-F 6"
ID: 195641
Premium Jumper Wire 50-Piece Rainbow Assortment F-F 6"
Premium Jumper Wire 50-Piece Rainbow Assortment F-F 6"
These premium jumper wires are stranded 26 awg wires with female terminations on both ends, for use with 0.1" (2.54 mm) male headers. The assortment of 6" (15 cm) wires includes five each of ten different colors.
 |
These premium jumper wires, which are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attached, are great for making quick and easy prototyping connections. They are available in three lengths—3" (7.5 cm), 6" (15 cm) and 12" (30 cm)—and in ten colors:
- black
- brown
- red
- orange
- yellow
- green
- blue
- purple
- gray
- white
These are the same colors as those used on resistor color codes and rainbow ribbon cable. We offer the 6" and 12" cables as monochromatic 10-packs (in the color of your choosing) and rainbow-assortment 50-packs (five pieces of each color). The 3" cables are only available as rainbow-assortment 50-packs. For longer cables, see our wires with pre-crimped terminals, which are available in lengths of 3", 6", 12", 24", 36", and 60".
These wires can be purchased with male terminations on both ends, female terminations on both ends, or one male and one female termination. These terminations are designed for use with 0.1" (2.54 mm) male headers and female headers, solderless breadboards, and prototyping PCBs. Close-up pictures of the male and female terminations are shown below.
|
|
 |
3" (7.5 cm) rainbow assortments:
- Female- to-female
- Male- to-female
- Male- to-male
6" (15 cm) rainbow assortments:
- Female- to-female
- Male- to-female
- Male- to-male
12" (30 cm) rainbow assortments:
- Female- to-female
- Male- to-female
- Male- to-male
People often buy this product together with:
 |
Premium Jumper Wire 50-Piece Rainbow Assortment M-F 6" |
 |
Premium Jumper Wire 50-Piece Rainbow Assortment M-M 6" |
 |
Premium Jumper Wire 50-Piece Rainbow Assortment F-F 3" |
195641
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
Analog Test Shield for Arduino Development, AD/DA. Integrates DAC circuit and amplifier circuit.
Retired
No product available!
USB TO UART solution with USB micro connector. Waveshare 11315
Retired
No product available!
Waveshare WIFI501 is a mother board designed to be used with WiFi modules like WIFI232 series, WIFI-LPT100. It provides an easy way to test/evaluate these WiFi to UART modules
Retired
No product available!
No product available!
No product available!
Banana Pi M2+ is another ARM SoC powered development board that offers great computing performance in an ultra portable form factor. It is a 65mm square with Allwinner H3 Quad-core A7 SoC and 1GB DDR3 RAM
Retired
No product available!
Self-assembly DIY enclosure for Banana Pi M2+, transparent
Retired
No product available!
Lithium Polymer rechargeable cell with a Protection circuit. Compatible with ODROID-C0
Retired
No product available!
MYIR MYC-JA5D44 is a single-board computer in the form of a card with SO-DIMM 200-pin connector. The SAMA5D44 processor from Atmel, based on Cortex-A5 cores, has been equipped. It can work with a maximum frequency of 600 MHz. It has 512 MB of DDR2 SDRAM, 512 MB of NAND Flash memory. GPIO ports, interfaces have been derived on the SO-DIMM 200-pin connector.
Retired
No product available!
MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
Retired
No product available!
UART GPS Module, NEO-7M-C onboard, straight/vertical pinheader
Retired
No product available!
The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133
Retired
No product available!
Programmed layout for a dual-function acoustic switch. AVT3144 UK
Retired
No product available!
A set for self-assembly of a dual-function sound switch. AVT3144 B
Retired
No product available!
Printed circuit board and programmed clock system with a 20mm display set by means of GPS. AVT5522 / 1 A +
Retired
No product available!
AVT kit for self-assembly of an accurate clock with a 20mm display set by means of GPS. AVT5522 / 1 B
Retired
No product available!
Premium Jumper Wire 50-Piece Rainbow Assortment F-F 6"