.png)
- Out-of-Stock
SPI controller - USB
ID: 201571
The controller allows you to easily control the work of any device with the SPI interface via the USB port. All you need is a FTDI USB driver . TOL-09235
TOL-09235 - SPI Shortcut
Description: The SPI Shortcut allows you to control SPI pins over USB, allowing for a virtual "SPI Terminal." Using basic serial commands, you can access any SPI device such as sensors, media, and even some devices. You can change all of the SPI features (frequency, data order, etc.) on the fly with no involved! Comes with a simple-to-use terminal interface. All you need is the FTDI USB driver and a basic terminal program.
Documents:
201571
Manufacturer
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Responsible person
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Other products in the same category (16)
Male terminal block, angled, 12-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-12P
Retired
No product available!
Female terminal block, 2-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-2P
Retired
No product available!
Female terminal block, 3-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-3P
Retired
No product available!
Female terminal block, 4-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-4P
Retired
No product available!
Female terminal block, angled, 2-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-2P
Retired
No product available!
Female terminal block, angled, 3-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-3P
Retired
No product available!
Female terminal block, 2-pin. Pitch 5.0mm. Height 15mm. Suitable for 2EDGRC male strips with a pitch of 5.0 mm. 2EDGKN-5.00
Retired
No product available!
A minicomputer with a Rockchip RK3399 processor and 4GB of RAM and 32GB of eMMC memory. It features two Ethernet ports, two USB 3.0 ports, USB Type C and a microSD slot. The case includes. FriendlyELEC NanoPi R4SE
Retired
No product available!
MEMS microphone module that will allow voice detection, sound recording or audio transmission. It communicates via an I2S interface. DFRobot SEN0526
Retired
No product available!
Camera module with Sony Starvis IMX327 sensor that works with Raspberry Pi minicomputers. It has a 2 MP sensor and an 80° viewing angle lens, and is equipped with a motorized IR-CUT filter. ArduCAM B0425
Retired
No product available!
Camera module with Sony Starvis IMX462 sensor that works with Raspberry Pi minicomputers. It has a 2 MP sensor and an 80° viewing angle lens, and is equipped with a movable IR-CUT filter. ArduCAM B0423
Retired
No product available!
5-channel SATA expander equipped with M.2 B Key connector. It supports HDD and SSD drives that work with the SATA protocol. Waveshare M2-SATA-5P
Retired
No product available!
2-channel M.2 SATA expander equipped with PCIe X1 connector. It supports support for SSDs that work with the SATA protocol. Waveshare PCIe-SATA-M2-2P-A
Retired
No product available!
The REBEL reinforced repair adhesive tape (0.26 mm x 50 mm x 5 m) is a durable, silver tape with excellent adhesion to surfaces such as PVC, plastic, aluminum, and steel. It is ideal for repair, insulation, and assembly work, withstanding temperatures up to 180°C.
Retired
No product available!
Low cost programmer for STM32 and STM8 microcontrollers fully compatible
with the ST-Link V2
Retired
No product available!
WiFi module dedicated to Coral Dev Board Micro. It uses the Murata LBEE5HY1MW chip and connects to the base board via B2B connectors. Coral G650-07974-01
Retired
No product available!
The controller allows you to easily control the work of any device with the SPI interface via the USB port. All you need is a FTDI USB driver . TOL-09235