- Out-of-Stock

Very small and super-light polymer lithium battery. Thanks to the new polymer-ion chemistry, a very good ratio of the battery's capacity to its mass was obtained. The battery has leads in the form of two wires terminated with a JST-PH connector. The battery has built-in protection against overvoltages, too high power consumption and against too low discharge.
Attention!
Li-Po batteries require a special charging method and the battery should be charged with chargers designed for lithium-polymer batteries.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
UNIVERSAL ULTRASOUND REPRESENTATIVE (NOZZLES DO NOT LIKE !!!) - SELF-ASSEMBLY KIT
No product available!
No product available!
Integrated analogue base station RFID (front-end) of the company EM Microelectronic with a frequency of 13.56MHz. The system has a SOP20 housing
No product available!
No product available!
Electronics Explorer: All-in-one USB Oscilloscope, Multimeter & Workstation. 410-151
No product available!
No product available!
Printed circuit board for water level indicator. AVT1949 A
No product available!
Magnetic Displacement Sensors, SOIC8, Honeywell Microelectronics & Precision Sensors, RoHS
No product available!
No product available!
It is used to monitor the temperature measurement and other parameters. The expansion module has an I2C / 1-Wire converter (DS2482) through which DS18B20 temperature sensors can be connected using two or three wires. MOD-29.Z
No product available!
No product available!
CO2 sensor module with MG811 system with a voltage of 6 V. The module has an analogue output of 30 ... 50mV and TTL
No product available!
No product available!
No product available!
No product available!
No product available!
Battery: Li-Po; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 5 x 25 x 35mm. PRT-10718