• Out-of-Stock
Ładowarka USB/DC ogniw LiPol/LiIon
search
  • Ładowarka USB/DC ogniw LiPol/LiIon
  • Ładowarka USB/DC ogniw LiPol/LiIon
  • Ładowarka USB/DC ogniw LiPol/LiIon
  • Ładowarka USB/DC ogniw LiPol/LiIon
ID: 203744

Adafruit 280 - USB/DC Lithium Polymer battery charger 5-12V - 3.7/4.2v cells

Retired
Kamami is the official distributor of Adafruit modules and development kits. All boards of this brand in our offer are original and come directly from the manufacturer.

280 - USB/DC Lithium Polymer battery charger 5-12V - 3.7/4.2v cells

Description

Charge your single-cell lithium ion/polymer battery any which way you like with this board. Have a USB connection? No problem, just plug into the miniUSB connector. Only have a wall adapter? Any standard 2.1mm DC adapter which puts out 5 to 12VDC will work fine. If both are plugged in, the charger will automatically choose whichever has the highest voltage.
Other nice things about this charger include multiple LEDs for power & charging status, including a charging LED which will blink when the battery is full. If the charger gets too hot from high-speed charging, it will slow down the charge rate automatically. You can easily adjust the charge rate up to 1.2A or down to 100mA.

    >
  • Use USB or DC power - 5 to 12V input
  • Charges one single-cell 3.7/4.2v batteries (not for older 3.6/4.1v cells) with constant current/constant voltage
  • Three indicator LEDs - green for Power, orange for charging and red for error
  • Charging LED will blink when the battery is full
  • You don't have to worry about heat dissipation in the charger, even when plugging in a 12V DC power jack - thermal protection inside will slow down the charge rate to prevent damage
  • 2 JST connections so you can keep the battery plugged in and powering your project
  • Terminal block connections galore (if you don't like JST connectors) just solder in 3.5mm terminal blocks
  • Default charge rate is about 280mA, but you can easily change this by soldering in a through-hole resistor on. The chip can do 100-1200 mA charging
  • Safety timer will stop charging after about 14 hours
  • The chip supports a standard 10K thermistor, which we have stuffed as a standard resistor. You can solder in a thermistor easily
  • Lots of information in the datasheet for the MCP73861
  • Fully assembled, tested and comes with a free JST cable
  • Schematic available for your perusal
  • Dimensions: 1.75" x 1.6"


Note:Battery, USB cable and DC power plug not included.

Details

  • Dimensions: 40mm x 44mm x 13mm (1.6in x 1.7in x 0.5in)
  • Weight: 11.7g ( 0.4oz)
203744

Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Other products in the same category (16)