• Out-of-Stock
Segger J-Link 5V JTAG Adapter (8.08.15)
search
  • Segger J-Link 5V JTAG Adapter (8.08.15)
ID: 205023

J-Link 5V JTAG Adapter, RoHS, Segger

Retired
Kamami is the official distributor of Segger programmers, probes and accessories. All products of this brand in our offer are original and come directly from the manufacturer.

J-Link 5V JTAG Adapter, RoHS, Segger

The J-Link 5V JTAG Adapter extends the output voltage range of J-Link to 5V. Most targets have JTAG signals at voltage levels between 1.2V and 3.3V. These targets can be used with J-Link ARM without a 5V adapter. Higher voltages are common primarily in the automotive sector.
Note: Current J-Links are 5V tolerant, but output levels are limited to about 4V (See J-Link specifications for more details).
These output levels are sufficient for most 5V targets, meaning that current J-Links can be used with most 5V targets without adapter. The adapter is only required for 5V targets that require (input) signals above 3.3V.

Technical data

  • 20 pin connector, female (plugs into J-Link)
  • 20 pin connector male, for target ribbon cable
  • LED shows power status
  • Adapter is powered by target
  • Power consumption < 20 mA
  • Target supply voltage: 3.3V - 5V
  • Max. JTAG-frequency: 12 MHz


Compatibility noteThe J-Link ARM 5V JTAG adapter is compatible to J-Link ARM revisions 5 or newer.

Usage

The 5V JTAG adapter should be plugged directly into J-Link ARM with the 20 pin female connector. The target ribbon cable is then attached to the 20 pin male connector of the adapter. The picture below shows a J-Link ARM with a connected 5 volt adapter.


Code: J-Link 5V JTAG Adapter (8.08.15)

205023

Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Other products in the same category (16)