- Out-of-Stock
New products
New products New products
zł301.74
24h
Dostępny
Available
Available
zł59.04
24h
Available
AVT1747 A
ID: 208312
HEADPHONE AMPLIFIER WITH TPA6111 - PLATE PRINTED
HEADPHONE AMPLIFIER WITH TPA6111 - PLATE PRINTED
Producer: AVT
The better parameters of the headphone pickups and the fact that they are very close to the ears cause that the signal from the amplifier must be of very good quality, free of noise and hum and any other distortion. The present amplifier is characterized by very good parameters, and the TPA6111 system used in it is a specialized headphone amplifier from Texas Instruments.
The printed circuit board and documentation are included.
A detailed description in EP7 / 13 or 
208312
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
Based on Wi-Fi AP-Soc open source development board hardware
Retired
No product available!
No product available!
Needle bending needle, for precise glue application, Flux 0,21mm internal diameter and 1.26mm outside diameter
Retired
No product available!
Minicomputer with a dual-core processor (up to 2.0 GHz) and 4 GB of LPDDR3 RAM memory, 16 GB of eMMC Flash memory. It has a two-band WiFi 2.4G and 5G module. Supports GPU and VPU acceleration. It has video interfaces in the form of HDMI, as well as USB 3.0, USB2.0, MicroSD, Ethernet port and 3.5mm audio socket. FriendlyElec NanoPC-T4
Retired
No product available!
No product available!
No product available!
No product available!
Li-Po battery 3.7V / 500mAh, PCM protection, connector + JST-BEC 2,54 socket, 2 pins, cable length 150mm
Retired
No product available!
No product available!
No product available!
Stanisławski Włodzimierz, Raczyński Damian
Delivery date unknown
No product available!
No product available!
No product available!
It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.
Retired
No product available!
Side panel with sensors for Totem Mini Lab and Totem Micro Lab sets. The board has a microphone, OLED display, DH11 humidity sensor, NTC thermistor, buzzer and a DC motor control module. Totem TE-SP02-B
Retired
No product available!
HEADPHONE AMPLIFIER WITH TPA6111 - PLATE PRINTED