- Out-of-Stock
MULTIODORNIK ELF-VLF - RECEIVER VERSION Ia, Ib - PCB PLATE
Producer: AVT
The ELF-VLF receiver, or rather a set of receivers, enables reception of mysterious radio signals with extremely low frequencies. It is possible to observe signals of communication with submarines and so-called Schumann resonance.
It is possible only in extra-urban conditions (eg during trips), and this is due to the high level of industrial disturbance in cities. In the city, the described systems can be used, for example, to observe storms and the level of industrial disturbances. Such their use can also be very interesting. A lot of information about the reception of electromagnetic waves at very low frequencies, below 30kHz, as well as about antennas used for this type of receivers, is provided in the article 'Receiving ELF-VLF radio waves'.
The project presents four receivers, designed to receive radio signals (electromagnetic waves) in the range from 3Hz to 30kHz, thus including bands: ELF, SLF, ULF and VLF. The first of the receivers (I) cooperates with a wire antenna, reacting to the electrical component of the electromagnetic field. It was made in two system versions (Ia and Ib). The third and fourth are designed to cooperate with a loop antenna, reacting to the magnetic component of the electromagnetic field. The article also describes the system generating symmetrical power supply voltage and systems improving work comfort by increasing resistance to unwanted signals: two low-pass filters with band respectively 200Hz and 20kHz, bandpass filter, reducing the hum of 50Hz and optoisolator m signals .cz. The described systems do not require tuning or startup, so that even a novice electronics can do it. The big advantage of these systems is the low cost of their implementation.
Note: the project has been divided into 6 parts:
AVT3054 / 1
The receiver can be made in two system versions (Ia and Ib), differing in the applied solutions and the resulting operational parameters. The second version of the receiver performs better in sunny and windy weather, but is less immune to industrial interference. Both versions of the receiver use the popular TL072 integrated circuit, which includes two independent operational amplifiers.
To connect the antenna to the receiver, reacting to the electrical component of the electromagnetic field, do not use coaxial cables, because they act as a capacitive voltage divider. During thunderstorms, the receiver's input from the antenna should be disconnected and the antenna itself should be grounded.
Includes AVT3054 / 1 printed circuit board and documentation.
Detailed description in EdW3 / 13 or ![]()
Additional materials:
Article 'ELF-VLF radio reception' from the journal Elektronika Dla Wszystkich 10/2011
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
A two-channel DDS signal generator with a range of up to 40MHz ensures precise signal generation thanks to DDS technology with an accuracy of 0.01uHz. The device offers 12-bit vertical resolution, 1mV amplitude resolution and 50Ω output impedance, making it irreplaceable in electronics laboratories. Junctek JDS6600-40
No product available!
Vector network analyzer with two ports. It can perform measurements for frequencies from 50 kHz to 3 GHz. Equipped with an LCD display, it can be connected to a computer via USB. NanoV2 3.2"
No product available!
SDR (Software Defined Radio) receiver that allows you to receive signals in the frequency range from 10 kHz to 1 GHz. It is ideal for both monitoring low frequencies and receiving signals on higher bands
No product available!
Thermal imaging camera module with an MLX90640 infrared sensor and a 2.8" TFT LCD display. It offers an accuracy of 2°C and a viewing angle of 55°x35°.
No product available!
Antenna dedicated to communication in LoRa networks in the 868 MHz frequency band. Equipped with an RP-SMA connector. SparkFun WRL-18083
No product available!
Visible spectrum emitter module that combines 9 discrete LEDs covering visible light wavelengths from 455 to 720 nm. It uses Qwiic connectors and I2C communication as well as a USB type C socket to power the module. SparkFun SPX-21316
No product available!
WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21250
No product available!
MP3 player module controlled by I2C interface or switching inputs. It is based on a 1.4 W audio amplifier. The board has a 3.5 mm audio output and a connector for connecting a loudspeaker. Files are played from a microSD card. SparkFun DEV-19030
No product available!
A set with an adapter dedicated to the FLIR Lepton thermal imaging camera and the Lepton FS camera. It has been pre-configured to operate as a plug-and-play UVC 1.0 USB camera, it can also communicate via UART and I2C interface. SparkFun DEV-20813
No product available!
Motion detection module featuring Panasonic\'s EKM series PIR sensor. The EKM series is optimised for detecting small movements and is ideal for detecting movement in a small area around the sensor. It offers digital output in 32 zones with a detection distance of 5 m and a detection area of 90° x 90°. SparkFun SEN-22000
No product available!
Antenna dedicated to communication in LoRa networks in the 868 MHz frequency band. Equipped with an RP-SMA connector. SparkFun WRL-18082
No product available!
Sensor module for electromyography (EMG). Allows muscle activity to be studied and used to control devices. SparkFun DEV-21265
No product available!
Portable soldering iron with a power of 65 W. It has an adjustable operating temperature in the range of 50 ° C to 400 ° C. It can be powered via a DC or USB type C connector. The set includes a soldering iron and a BC2 tip. MiniWare TS101 (BC2) Blue
No product available!
Flexible 25 cm microSD to SD adapter. Supports all card capacities and types including: 16GB, 32GB, 64GB, 128GB Micro SD/SDHC
No product available!
DAC converter with built-in headphone amplifier. It is powered by DC 5V/1A and can work with various power sources, ensuring operational stability and excellent sound quality. DAC-Q3 Pro
No product available!
The digital meter with smart testing function is an advanced measuring device that offers a wide range of functions and capabilities. It is compact and portable and complies with safety standards for accurate and reliable measurement results.
No product available!
MULTIODORNIK ELF-VLF - RECEIVER VERSION Ia, Ib - PCB PLATE