- Out-of-Stock
AVT735 C
ID: 208731
PULSE REGULATOR - A SYSTEM HOLDING AND LAUNCHED
PULSE REGULATOR - A SYSTEM HOLDING AND LAUNCHED
Producer: AVT
A simple and reliable controller switched on between the power source and the receiver. The power supply may come from a battery or an AC adapter with adequate current capacity. The load can be any DC motor or bulb. Thanks to the pulse work, there is almost no energy loss in the system. The control transistor does not require a heat sink. The system works perfectly for adjusting the speed of a modeling drill. At low speeds, it ensures tool work with relatively high torque. Examples of attachments: Model Drilling Controller, Lossless Bulb Dimmer
The device is particularly recommended for modelers and electronics who prepare printed circuit boards by themselves
Selected parameters of the regulator:
- for adjusting the speed of modeling drills
- the ability to control the brightness of the bulb 6-24 V and power 100 W
- possibility of optimizing parameters for a specific cooperating device
- maximum output current 10 A
- efficiency - close to 100%
- regulation of the output course - smooth, potentiometer
- 6 - 25 V power supply
- system assembled and running
- Detailed description in
- or
208731
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
UART GPS Module, NEO-7M-C onboard, straight/vertical pinheader
Retired
No product available!
FPGA starter kit with Intel Stratix 10 GX. The module has integrated transceivers that transfer data at speeds up to 28.3 Gb/s, making DE10-Pro fully compatible with version 3.0 of the PCI Express standard. The DE10-Pro offers fast parallel Flash memory and four SO-DIMM slots that support DDR4 SDRAM options. Terasic DE10-Pro-GX-280-8G (P0626)
Retired
No product available!
No product available!
4-digit 7-segment display with MAX7219 driver chip. Adafruit 1268
Retired
No product available!
Minicomputer with Amlogic S922X processor, which integrates the ARM Cortex-A73 quad-core chip and Cortex-A53 dual-core with Mali-G52 GPU and 4GB of RAM. Additional equipment includes: eMMC memory slot, HDMI, microSD card slot and 40-pin GPIO connector. Hardkernel Odroid N2L
Retired
No product available!
The expansion board with the LoRaWAN SX1302 and GNSS L76B module is dedicated to Raspberry Pi minicomputers. The kit includes the 868M antenna, GPS and necessary cables. Waveshare SX1302 LoRaWAN Gateway HAT
Retired
No product available!
No product available!
No product available!
ARK terminal connector spring 11-pin, pitch 3.5 mm, non-detachable.
Retired
No product available!
No product available!
No product available!
No product available!
Printed circuit board of the '51 family of microcontrollers programmer with Flash memory and EPROM in housings with 20 or 40 pins
Delivery date unknown
No product available!
No product available!
Kit for building a giraffe robot controlled by a wire with a switch. Totem TKR-GRF
Retired
No product available!
The set allows introducing distance, ambient lighting and gesture analysis into the subject using the VL6180X sensor. NUCLEO-F401RE plate in the set with the VL6180X expansion board. P-NUCLEO-6180X1
Retired
No product available!
PULSE REGULATOR - A SYSTEM HOLDING AND LAUNCHED