Cubie Baseboard

The Arduino 4 Relays Shield allows your Arduino driving high power loads that cannot be controlled directly by Arduino\'s digital pins. The Shield features four relays, each relay with 2 pole changeover contacts (NO and NC). Four LEDs indicate the on/off state of each relay. (A000110)

HK Turnigy 4000mAh 2S 30C hardcase pack (ROAR APPROVED) (21004)

Needle bending needle, for precise glue application, Flux 0.413mm internal diameter and 0,7176mm outside diameter

Orangutan SVP-324 Robot Controller (partial kit)

Jan (ed.) Pilarczyk

HAT designed for Raspberry Pi 3B+ and Raspberry Pi 4B minicomputers. HAT enables direct power supply of the minicomputer from the Ethernet port. The module is powered by 37 to 57 V, supplies 5V and 3A. ArduCam U6102

Information and advertising board with red LEDs - a set for self-assembly

3-pin ARK mounting strip, 5.0 mm pitch. 301-5.0-03P-12-00A(H)-BL

The eMMC 5.1 flash memory module for Hardkernel Odroid C2 computers. 32GB capacity, Android operating system installed. The set includes a microSD adapter. Hardkernel

LAUNCHING KIT FOR AVR I 51 - SELF-ASSEMBLY KIT

Open-source All-in-one Instrumentation. Digilent 410-324

8 GB eMMC module for Odroid-U2/U3

FAZER GUITAR EFFECT - PRINTED PLATE

Grapic LCD 128x64, 93x70mm, with backlight (yellow/green), ST7920 controller, character generator, 8bit, 4bit and serial interface

The module has a humidity sensor (accuracy ± 2% RH) and temperature with an accuracy of ± 0.3 ° C. Communication takes place via the I2C bus.