Turnigy D3530 / 14 1100KV Brushless Outrunner Motor

AVT kit for self-assembly of a practical workshop power supply. AVT3172 B

Filament from ROSA3D made of high-quality PLA pellets. Placed on a cardboard thimble, on which 1 kg of 1.75 mm diameter filament is wound. ROSA3D ReFill PLA Starter Yellow

RS232 INTERFACE WITH GALVANIC SEPARATION - PRINTED PLATE

NanoPi NEO is a miniature board with the all-in-one SoC Allwinner H3 chip (ARM Cortex-A7) with built-in Ethernet communication. Works with Ubuntu MATE, Debian, etc. It can be powered by the microUSB port. The board also contains a USB port, a serial port and a 36-pin GPIO connector.

Portable Flash Programmer for on-chip and external flash memory

High quality XF-ABS filament for 3D printer with 1.75 mm diameter. 1 kg of wire is wound on the spool.

INTELLIGENT WIPER DRIVER - SOFTWARE

DIGITAL GUITAR EFFECT - PROGRAMMED SYSTEM

D / AZ TRANSDUCER WITH THE TDA1541 SYSTEM - PRINTED PLATE

Evaluation board with high voltage SMPS ALTAIR05T-800 SMPS switch / controller. The board is equipped with a 5W (5V / 1A) power charger with a wide voltage range and constant current. STMicroelectronics EVLALTAIR05T-5W

Stabilized laboratory power supply Wanptek with variable voltage regulation in the range from 0 to 60V and current in the range of 0 to 5A. Wanptek KPS605D

3-pin ARK mounting strip, 5.0 mm pitch. 301R-5.0-03P-12-00A(H)

Shield X-NUCLEO-IHM09M1 from ST allows you to connect BLDC motor driver modules for STM32 Nucleo tiles

AVT kit for self-assembly of an automatic charger for lead-acid batteries. AVT3120 B

GIGANTIC LED DISPLAY 27cm - PLATE

MYIR MYC-C7Z010 is a single board module based on the MYC-C7Z010 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.