- Out-of-Stock
Turnigy Multistar 60 Amp Multi-rotor Brushless ESC 2-6S (OPTO)
ID: 229371
Turnigy Multistar 60 A - Brushless motor controller for 2-6S multirotors (OPTO) (HK45503)
Turnigy Multistar 60 A - Brushless motor speed control for 2-6S multirotors (OPTO) (HK45503)
MultiStar ESCs speed controllers offer high quality and are also inexpensive! Designed for simple structures and easy to assemble controllers, they proved to be ideal for multirotors.
The controller is characterized by smooth development of power without limiting power. Security is also not neglected by equipping the controller with LVC (Low Voltage Cut-off), overload protection in the event of a motor lock, protection in the event of a lack of control signal and safe arming.
Multistar controllers are factory equipped with Gold connectors adapted to the current range of the regulator.
Functions:
• Linear power control
• Quick reaction
• Atmel microcontroller
• Protection in the event of engine blockage
• Protection in the event of signal loss
• Safe startup
• Ability to control 480 Hz + signals (up to 499 Hz)
• Possibility to use the programming card
Specification:
Continuous current: 60 A
Power supply: 2-6 S Lipo
BEC: No (OPTO)
PWM: 8 kHz
Max. RPM: 240000 rpm for a 2-pole brushless motor
PCB size: 68 mm x 32 mm
Power connector: male 4 mm
Motor connector: female 4 mm
Weight: 62 g
PRODUCT ID: 9351000034-0
229371
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
KAmduino UNO is a development board with functionality and dimensions typical for Arduino UNO. Thanks to the built-in ATmega328P microcontroller and the FT231X chipset, the board can be programmed via a USB interface using the Arduino environment. KAmduino UNO
Retired
No product available!
K64 microcontroller with ARM® Cortex®-M4 core, 1MB Flash memory, 256kB RAM, 120MHz, SPI, I2C, I2S, UART, CAN, USB OTG, ADC, DAC, RTC, DMA, LQFP100
Retired
No product available!
SmartLED Shield driver (V4) for SmartMatrix series displays, for use with Teensy 3.2, Teensy 3.5 and Teensy 3.6. It is also possible to connect LED Dotstar or APA102 displays. Adafruit 1902
Retired
No product available!
Add motion, direction and orientation sensing to your wearable FLORA project with this high precision 9-DOF sensors: 3-axis accelerometer, 3-axis magnetometer and 3-axis gyroscope. Adafruit 2020
Retired
No product available!
Ambient Light Sensor, SI1145, connects to the I2C bus pads. Adafruit 1981
Retired
No product available!
Extension for Raspberry Pi; communication module with RS-485 interface (DEV-13000). Module with the possibility of mounting the DB-9 socket, the socket should be purchased separately
Retired
No product available!
FreeSoC2 board has two processors on-board: a CY8C5868LTI-LP039 and a CY8C5888AXI-LP096. The former serves as a debugger/programmer for the latter, which is the target upon which your application code will be installed. Both parts contain a Cortex-M3 processor core, 256kB of flash memory, 64kB of SRAM, and 2kB of EEPROM. DEV-13229
Retired
No product available!
32-bit microcontroller with ARM Cortex-M4 core, XMC4200 family, 256kB Flash, VQFN-48, Infineon
Retired
No product available!
Aluminum extensometer beam, allowing measurement of weight up to 1 kilogram. It has four wires. It is used in kitchen scales and portable scales.
Retired
No product available!
Aluminum extensometer beam, allowing weight measurement up to 3 kilograms. It has four wires. It is used in kitchen scales and portable scales.
Retired
No product available!
Aluminum extensometer beam, allowing mass measurement up to 5 kilograms. It has four wires. It is used in kitchen scales and portable scales.
Retired
No product available!
The set allows introducing distance, ambient lighting and gesture analysis into the subject using the VL6180X sensor. NUCLEO-L053R8 plate in set with VL6180X expansion board. P-NUCLEO-6180X2
Retired
No product available!
Shield for STM32 Nucleo, has two MP34DT01-M digital microphones made in MEMS technology
Retired
No product available!
9-inch display with universal HDMI interface and 10-point multitouch capacitive screen
Retired
No product available!
Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. SEN-13230
Retired
No product available!
Shadow Chassis is a marvelously durable and modular robot platform from RobotZone. The chassis plates and mounts are cut from ABS plastic and utilize the Actobotics 0.77" and 1.50" hub patterns for sensors, controllers, power, etc. With the included “snap on” micro-controller mounts, you can attach an Arduino, Raspberry Pi, SparkFun RedBoard, or SparkFun RedBot Mainboard!
Retired
No product available!
Turnigy Multistar 60 A - Brushless motor controller for 2-6S multirotors (OPTO) (HK45503)