ZYBO Zynq-7000 ARM/FPGA SoC Trainer Board - ACADEMIC (410-279P-KIT)

ATTENTION! This product is for academic recipients (students and academic teachers) only!

After the ordering, please send us by e-mail the data listed below:

• the name and last name
• position (student, teacher)
• e-mail (with the University domain)
• University name
• Facultie / Section
• University address
• University phone no.
• Notice! Students must send a copy of University Identity Card (by e-mail)

Description

The Zybo (Zynq™ Board) is a feature-rich, ready-to-use, entry-level embedded software and digital circuit development platform built around the smallest member of the Xilinx Zynq-7000 family, the Z-7010. The Z-7010 is based on the Xilinx^® All Programmable System-on-Chip (AP SoC) architecture, which tightly integrates a dual-core ARM Cortex-A9 processor with Xilinx 7-series field programmable gate array (FPGA) logic. When coupled with the rich set of multimedia and connectivity peripherals available on the Zybo, the Zynq Z-7010 can host a whole system design. The on-board memories, video and audio I/O, dual-role USB, Ethernet and SD slot will have your design up-and-ready with no additional hardware needed. Additionally, six Pmod connectors are available to put any design on an easy growth path. 

The Zybo provides an ultra-low cost alternative to the ZedBoard for designers that don't require the high-density I/O of the FMC connector, but still wish to leverage the massive processing power and extensibility of the Zynq AP SoC architecture.

Features

• Xilinx Zynq-7000 (XC7Z010-1CLG400C)
• 28,000 logic cells 
  
• 240 KB Block RAM 
  
• 80 DSP slices 
  
• On-chip dual channel, 12-bit, 1 MSPS analog-to-digital converter (XADC) 
  
• 650 MHz dual-core Cortex™-A9 processor 
  
• On-board JTAG programming and UART to USB converter  
  
• DDR3 memory controller with 8 DMA channels 
  
• 512 MB x32 DDR3 w/ 1050Mbps bandwidth 
  
• 128 Mb Serial Flash w/ QSPI interface  
• microSD slot (supports Linux file system) 
• High-bandwith peripheral controllers: 1G Ethernet, USB 2.0, SDIO 
  
• Low-bandwidth peripheral controller: SPI, UART, I2C 
  
• Dual-role (Source/Sink) HDMI port 
  
• 16-bits per pixel VGA output port
• Trimode (1Gbit/100Mbit/10Mbit) Ethernet PHY 
  
• OTG USB 2.0 PHY (supports host and device)
• External EEPROM (programmed with 48-bit globally unique EUI-48/64™ compatible identifier) 
  
• Audio codec with headphone out, microphone and line in jacks 
  
• GPIO: 6 pushbuttons, 4 slide switches, 5 LEDs  
  
• Six Pmod ports (1 processor-dedicated, 1 dual analog/digital)