CAT93C86LI-G EEPROM memory

The RASPBERRYPI-2-MODB-1GB is a second generation Raspberry Pi

Waveshare camera module with OV7670 chip, 0.3 megapixels, resolution up to 640x480 pixels. It enables downloading of images in various formats via the Serial Camera Control Bus (SCCB) interface at 30 fps. Waveshare 9828

Raspberry Pi 3 & MathWorks Learn to Program Pack is a set consisting of a Raspberry Pi 3 computer with necessary hardware and MATLAB & Simulink Student Suite software. The set is designed for modeling and implementing solutions based on Raspberry Pi 3 in MATLAB and SIMULINK environments

IBM Watson IoT Platform is a set containing a computer Raspberry Pi 3 model B and Shield Raspberry Pi Sense HAT together with a course on modeling, simulation and analysis of projects related to Raspberry Pi 3 in IoT (Internet of Things) systems. PI3 IBM IOT LEARNKIT

Battery: Li-Ion; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 50.8 mm x 33.5 x 5.9 mm. PRT-13851

The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs

3DR Radio is a set that allows bidirectional transmission of telemetry data, eg between the RC model (with the APM controller) and a PC. Light and small device in a set with antennas and connecting cables. Radio modules have a power of 100mW (+ 20dBm) and transmit a signal over a distance of 1km.

A small USB splitter allowing to connect up to 4 USB devices, powered from the USB port

The Teensy is a breadboard-friendly development board with loads of features in a, well, teensy package. Each Teensy 3.2 comes pre-flashed with a bootloader so you can program it using the on-board USB connection: No external programmer needed! PJRC TEENSY32

PJRC TEENSYLC

This is the Teensy Audio board add-on for the Teensy 3.x line development boards. This audio board provides you with an easy-to-use tool to add high quality 16 bit, 44.1 kHz sample rate audio to your Teensy project. PJRC TEENSY3-AUDIO

EP11 / 16

EDW11 / 16

PCB for USB-1-Wire converter. AVT1787 A

AVT kit for self-assembly of the USB-1-Wire converter. AVT1787 B

Assembled USB-1-Wire converter. AVT1787 C