- Out-of-Stock
Very small and super-light lithium-ion battery. Thanks to the new Li-Ion chemistry, a very good ratio of the battery's capacity to its mass was obtained. The battery has leads in the form of two wires terminated with a JST-PH connector. The battery has built-in protection against overvoltages, too high power consumption and against too low discharge.
Attention!
Li-Ion batteries require a special method of charging and you must charge the battery with chargers designed for lithium-ion batteries.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
No product available!
No product available!
No product available!
No product available!
NetFPGA-SUME Virtex-7 FPGA Development Board. The amazingly advanced board that features one of the largest and most complex FPGA’s ever produced, a Xilinx Virtex-7 690T supporting thirty 13.1 GHz GTH transceivers. 410-301
No product available!
Set for self-assembly simulator dawn and dusk. AVT5480 B
No product available!
No product available!
Male terminal block, angled, 20-pin. Pitch 3.81mm. Height 7mm. 15EDGRC
No product available!
No product available!
The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V
No product available!
No product available!
No product available!
PCB and programmed system for 4-channel infrared switch controlled by any IR remote control. AVT1815 B
No product available!
Edition about ARM microcontrollers
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Capri Blue Satin
No product available!
Battery: Li-Ion; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 50.8 mm x 33.5 x 5.9 mm. PRT-13851