- Out-of-Stock
New products
New products New products
zł119.00
Delivery date unknown
zł119.00
Delivery date unknown
AVT1966 A - multi-input switch. PCB board
ID: 566127
Printed circuit board for multi-input switch. AVT1966 A
Description
The switch enables switching on a cooperating electricity receiver. It allows you to enable and disable it using three independent inputs. Thanks to this, it allows you to control a single device using various techniques: radio, wire, software eg from PLC, etc.
The assembly of the device is not difficult, but due to the potential tensions dangerous to life and health, it should be made under the supervision of a qualified person.
Project AVT 1966 EP 08/17
properties
- The dimensions of the tile 29x80mm
Included
- Printed circuit board
566127
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
Battery: Li-Po; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 5 x 25 x 35mm. PRT-10718
Retired
No product available!
George Greene, Young Cho, James Hartnett, Avram Bar-Cohen
Delivery date unknown
No product available!
UNIVERSAL AVR MICRO CONTROLLER PROGRAMMER - PRINTED PLATE AND PROGRAMMED SYSTEM
Retired
No product available!
No product available!
Card Kingston 32GB microSDHC Class 10 U3 UHS-I 90R / 80W + SD Adapter. Kingston SDCA3 / 32GB
Retired
No product available!
No product available!
This pretty little box brings a dash of mechanical magic to your home or office. Push the side lever and the box raises, tilts and opens its lid to reveal the contents. UGears 70001
Retired
No product available!
No product available!
The Arduino Ethernet Shield 2 allows an Arduino Board to connect to the internet. It is based on the Wiznet W5500 Ethernet chip. The Wiznet W5500 provides a network (IP) stack capable of both TCP and UDP. There is an onboard micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Uno and Mega
Retired
No product available!
No product available!
No product available!
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Emerald Green Satin
Retired
No product available!
No product available!
No product available!
NORS12DUO is a set consisting of two workshop organizers made of high quality plastic. It has the ability to regulate the size and number of compartments
Retired
No product available!
Printed circuit board for multi-input switch. AVT1966 A