- Out-of-Stock

Each electrical device requires the use of appropriate power supply. Therefore, there is an unrelenting need for useful laboratory instruments for the laboratory of less and more advanced electronics. Increasingly, prototype systems are being built on contact plates (power supply tested with SD-12NW board) and this power supply has been designed for this application.
Practice shows that the vast majority of electronic systems built today require the power supply with low current capacity and regulated voltage from 1.5 V to 20 V to be activated. It is best that the output voltage of such a power supply is smoothly regulated. In principle, the current efficiency does not have to be greater than 250 mA, because most of the systems built on contact plates are experimental or educational. A great convenience in the described power supply is the use of a digital voltmeter module with an LED display.
Project AVT 1990 EP 08/18
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Askja keyboard with US keyboard layout and 1.65m USB cable. UGo UKL-1588
No product available!
No product available!
No product available!
ROSA3D filament made of high-quality PLA granules. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Glow in the Dark Blue
No product available!
Module with a CCS811 air quality sensor for measuring the concentration of carbon dioxide (CO2) and volatile organic compounds (VOC) in the air. It communicates via the I2C interface. DFRobot SEN0339
No product available!
AVT kit for self-assembly of a remote 433 MHz two-channel switch (230VAC / 5A). AVT5455 B
No product available!
No product available!
Edition about ARM microcontrollers
No product available!
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and output on pads. It enables powering devices with 9 V or 12 V and testing chargers. PDC005
No product available!
Dispensing needle bent, for precise application of glue, flux with an inner diameter of 0.25 mm and an external diameter of 0.5 mm
No product available!
No product available!
No product available!
No product available!
ZP120.120.60UUJH TM PC - Hermetic housing ZP120.120.60 light with ears with seal and brass sleeves PC
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Neon Green
No product available!
No product available!
Assembled adjustable power supply for contact plates. AVT1990 C