STM32MP157C-DK2 - starter kit with STM32MP157C microprocessor

Description

STM32MP157C-DK2 is a starter kit with an application microprocessor from the STM32MP series from STMicroelectronic. The STM32MP157C system is a combination of a typical processor with a core Cortex-A7 and a microcontroller with a core Cortex-M4. The combination of these two cores allows users to create applications using the STM32 MPU OpenSTLinux Distribution software for the main processor and the STM32CubeMP1 software for the coprocessor. The chip is also equipped with a GPU graphics coprocessor (compatible with OpenGL ES 2.0).

The STM32MP1 microprocessor has integrated interfaces for external DRAMs. Thanks to the built-in hardware interfaces it can also directly use the memory of Flash eMMC constants, NAND Flash (serial or parallel), NOR Flash (serial), and SD cards. The kit also has a built-in Ethernet 1 Gb / s and USB interface. The system is powered by a specialized PMIC power supply system that integrates a 6-channel LDO stabilizer, a 3-channel DC / DC converter and a DC / DC converter.

The set is additionally equipped with a TFT 4 "480 × 800 display with a touch panel, WiFi module and Bluetooth 4.1 LE.

properties

• STM32MP157A based on a Cortex-A7 dual core 32 bits and Cortex-M4 32 bits MPU in a housing TFBGA361
• ST PMIC STPMIC1A power supply system
• 4-Gbit DDR3L, 16 bits, 533 MHz
• 1 Gbps Ethernet (RGMII) compatible with IEEE-802.3ab
• USB OTG HS
• Audio codec
• 4 user LEDs
• 2 user and reset buttons, 1 wake-up button
• USB 5 V / 3 A power input type C
• Connectors:
• RJ45 Ethernet
• 4 x USB Type A host
• USB Type-C DRP
• MIPI DSISM
• HDMI
• Jack connector (headphone jack with analog microphone input)
• MicroSD card slot
• GPIO extension connector (compatible with Raspberry Pi caps)
• Arduino Uno V3 expansion connectors
• 4 "480 × 800 pixel TFT display with LED backlight, MIPI DSISM interface and capacitive touch panel
• Wi-Fi 802.11b / g / n
• Bluetooth® Low Energy 4.1
• Built-in debugger / ST-LINK / V2-1 programmer with the ability to be used as USB: virtual COM port and debug port
• STM32CubeMP1 and full open-source Linux support STM32 MPU OpenSTLinux Distribution
• Support for integrated development environments (IDE), including IAR, Keil, GCC IDE