Category: RETIRED PRODUCTS

Xmega eXploreGO module with ATXmega128A4U microcontroller (version without MP3). The module is equipped with in DataFlash memory, microSD card connector. MOD-20 / AZ

MOD-21.Z - push button module with bistable operation. The sensor operates based on the AT42QT1012 system.

The Raspberry Pi GPIO connector adapter allows you to output signals from Raspberry Pi to the contact plate. Two LEDs indicate +3.3V and +5V power supply

MOD-23.Z

MOD-25.Z - touch sensitive button module with monostable function. The sensor operates based on the AT42QT1011 system.

MOD-26.Z

MT SPEC01 / 2015 RASPBERRY, ISSN 0462-9760

MOD-09.Z

Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire

Bi-directional converter enabling communication of any device equipped with an RS232 serial port with 802.11 b / g / n wireless WiFi network. The module can work as a TCP client / TCP or UDP server. The layout is "transparent" for communicating systems, which does not doubt facilitate communication between them.

Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1

Mobile battery with a capacity of 10,000 mAh for charging portable electronic devices, powered by 5V. The Kruger & Matz power bank is charged via a USB port , in a set with several terminals . KM0138

Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS

Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws

High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network

Kit for building a minisumo robot on a crawler chassis. It has a bulldozer, control board and a set of caterpillars. Robot version for self-assembly, requires additional motors and four AA batteries. Pololu 3124

Expansion module kit with Arduino compatible connectors for building a Zumo robot. The module includes a dual engine controller, buzzer and user button, as well as a 3-axis accelerometer and compass. Pololu 2508

1m USB A-microB USB cable, white-blue cable, flat pink RGB LED illuminated plugs

The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 12V.