Category: RETIRED PRODUCTS

Pre-installed Android 4.x or latest version. eMMC Version 5.0 interface or higher version from Samsung.
JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode

Pre-installed Ubuntu 14.04 or latest version. eMMC Version 5.0 interface or higher version from Samsung.
JEDEC/MMCA version 5.0 : HS400 interface with 8bit DDR mode

5V / 3.1A eXtreme power supply with microUSB plug for all Raspberry Pi computers (including Pi 3 model B and Pi 3 model B +)

Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 25mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 9 x 9 x 4mm

The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs

Arduino. 36 projects for electronics enthusiasts; Simon Monk

Orange Pi Plus is a computer with SoC Alwinner H3 (4 cores Cortex-A7, Mali400MP2 GPU), 1 GB RAM, 1 Gb Ethernet, WiFi 802.11 b / g / n. There are 4 USB 2.0 ports, a USB OTG port, a GPIO 2x20 connector compatible with Raspberry Pi 2 and a micro-SD card slot, 8GB EMMC Flash

Bluetooth 2.1 + EDR module based on RN41. It communicates via the UART interface. SparkFun WRL-12580

MOD-25.Z - touch sensitive button module with monostable function. The sensor operates based on the AT42QT1011 system.

MOD-17.Z

MOD-18.Z

The miniature digital potentiometer allows you to replace the analog potentiometer and control the resistance value using two buttons. The module contains inputs of the UP / DOWN buttons (for increasing and decreasing the resistance) and outputs in accordance with the analog potentiometer A, W, B (description on the circuit board). MOD-19.Z

Xmega eXploreGO module with ATXmega128A4U microcontroller (version without MP3). The module is equipped with in DataFlash memory, microSD card connector. MOD-20 / AZ

MOD-21.Z - push button module with bistable operation. The sensor operates based on the AT42QT1012 system.

The Raspberry Pi GPIO connector adapter allows you to output signals from Raspberry Pi to the contact plate. Two LEDs indicate +3.3V and +5V power supply

MOD-23.Z

MOD-26.Z

The SOIC adapter is used for testing circuits in SMD enclosures. The place for the stabilizer enables the selection of the supply voltage, as well as the supply of additional modules. The module is equipped with a filtering capacitor and space for a polymer fuse. MOD-14.Z

MOD-27.Z

The module enables connection of two devices with I2C interface working with different voltage levels. MOD-28.Z