Category: RETIRED PRODUCTS

AVT kit for self-assembly of a miniature 9V power module. AVT1913 / 9 B

Assembled module of a miniature 9V power supply. AVT1913 / 9 C

PCB board for miniature module power supply 5V, 9V, 12V, 15V, 24V. AVT1913 A

AVT kit for self-assembly of a miniature 12V power supply module. AVT1913 / 12 B

Assembled module of a miniature 12V power supply. AVT1913 / 12 C

AVT kit for self-assembly of a miniature 24V power supply module. AVT1913 / 24 B

PCBs and a programmed system for the construction of radar using ultrasonic waves. AVT5550 A +

A circuit board for a universal 2-channel relay module. AVT1914 A

Black plastic wheels designed specifically for use with FEETECH FS90R micro continuous rotation servos. The wheels have silicone tires and measure 60 mm (2.36″) in diameter. Two additional mounting holes for 4-40 screws make it possible to use the wheel with several of our universal mounting hubs. The wheels sold in pairs. Pololu 2819

Assembled radar using ultrasonic waves. AVT5550 C

Printed circuit board for LED ring illuminator. AVT1918 A

AVT kit for self-assembly LED ring illuminator. AVT1918 B

Assembled LED ring illuminator. AVT1918 C

PCB board and programmed layout for a configurable 4-channel switch. AVT1916 A +

AVT kit for self-assembly of a configurable 4-channel switch. AVT1916 B

Assembled configurable 4-channel switch. AVT1916 C

The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133

MYIR MYC-C7Z020 is a single board computer module based on the MYC-C7Z020 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.

Photon Wearable Shield makes it easy to add the WiFi enabled Photon to any wearables project. Each pin on the Photon is broken out into large sewing pins. Use conductive thread to make your next wearables projects. DEV-13328

The Kamami USB-Blaster is a programmer and configurator for PLD\'s manufactured by Altera. It is fully compatible with USB Blaster, then it can operate with a commercial and evaluation versions of the Altera Quartus project packet