7-segment LED display, 1 digit 14,20mm, yellow color (585nm), 2000 ucd (10mA), common anode, Pb-free. LED1-AS-B-05613BY

The high power motor driver module works on the basis of Infineon BTS7960B systems. Maximum controller current: 43 A, operating voltage range: 5.5V - 27V. The module has a heat sink and can be controlled from the Arduino, Raspberry Pi, and STM levels. IBT_2

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

A flexible cable type AA (tape) with a length of 20 cm. The tape has 20 wires and a pitch of 1 mm

Cabel USB Mini-USB-A 2.0 1,8m Black Lanberg CA-USBK-10CC-0018-BK

ARM7TDMI, 512kB Flash (ISP), 96kB RAM, USB 2.0 device/host/OTG, ADC, DAC, Ethernet, CAN, NXP, RoHS, LQFP 208

Female terminal block, 5-pin. Pitch 3.81mm. Height 7.8mm. Suitable for 15EDGRC male strips with a pitch of 3.81 mm. 2EDGKN-3.81

The SN74AHCT1G126DBVR is a single-input, three-state digital buffer ideal for bus and control applications. Compatible with TTL logic, it operates over a voltage range of 4.5V to 5.5V, making it suitable for systems with a variety of logic levels

White LED (cold, 6000-6500K) with 1W power equipped with a heat sink. Brightness approx. 80lm, viewing angle 120 degrees.

Female terminal block, 12-pin. Pitch 3.5mm. Height 15.6mm. KF2EDGK

Tact Switch 6.2x6.2mm, h = 5.5mm, 4-pin, straight, red, SMD

The current measurement with the value 0-20A is carried out by the ACS712-05 system based on the Hall effect. The sensitivity of the system is 100mV / A (analogue signal) .modACS712-20

The USB Step-Up 9V 6W converter module converts the input voltage in the range of 4.2-5.2V to a constant output voltage of 9V, with a maximum current of 1A and a conversion efficiency of 96%. The device can operate in a wide temperature range, from -40°C to 85°C, which makes it ideal for powering various electronic devices in harsh environments.

100cm flexible cable (tape) for connecting the camera module to Raspberry Pi computers. The tape has 15 wires and 1mm pitch

MicroSD memory card reader module with SPI interface. Leads with a pitch of 2.54 mm allow you to place the module, e.g. in a breadboard

Modular power supply with a power of 3 W, input voltage from 100 to 240 V and output voltage of 5 V. Designed for mounting on a PCB. Hi-Link HLK-PM01

350mW SURFACE MOUNT ZENER DIODE, SOT23-3, Diodes Incorporated, RoHS

Female terminal block, 6-pin. Pitch 3.81mm. Height 7.8mm. Suitable for 15EDGRC male strips with a pitch of 3.81 mm. 2EDGKN-3.81