Category: Modules with power outputs
There are 153 products.
The module contains a 5 V relay with a maximum current of 10 A (250 VAC) and optoisolated inputs, and with jumpers it is possible to select high or low switching. The module is equipped with screw connectors
Compact module with MOSFET IRF520 24V/5A transistor.
Module with a 12 V relay and a timer. It allows you to turn the device on and off cyclically at a specified time using potentiometers. It can also operate in single trigger mode, which allows the device to be turned on after a signal has been applied for a specified period of time. The operating time can be adjusted from 1 s to 100 s or from 1 s to 15 min
The module contains two 5V relays with a maximum current of 10A (250 VAC) and opto-isolated inputs, and with jumpers it is possible to select switching with high or low status. The module is equipped with screw connectors. modRL02_ISO
ModRL01 module with 10A/250VAC (10A/24VDC) relay, supply of 5 V load relay coil, additional control circuit, protected overvoltage control
Module with SSR 240V/2A relay controlled by 5V voltage with fuse. modSSR-1CH
Relay with a control voltage of 12 V and contact load capacity of 8A/250V AC or 8A/30V DC. It is characterized by stable operation in a wide temperature range. Finder 40.52.7.012.0000
Programmable time module with relay, allows you to set the time and manner of relay reaction on the trigger signal, has a built-in LED display. It can be supplied with voltage from the range of 6 - 30VDC or using the microUSB connector
The module contains four 5V relays with a maximum current of 10A (250 VAC) and opto-isolated inputs, and with jumpers it is possible to select switching with high or low status. The module is equipped with screw connectors. modRL04_ISO
Module with two 240V/2A relays controlled by 5V with a fuse triggered by a high state. modSSR-2CH-H
Module with one 240V/2A relay controlled by 5V with a fuse triggered by a high state. modSSR-1CH-H
Module with four 240V/2A relays controlled by 5V with a fuse triggered by a high state. modSSR-4CH-H
Module with eight 240V/2A relays controlled by 5V with a fuse triggered by a low state. modSSR-8CH-L
Module with MOSFET transistor, 5-36 V, 20 A, switching frequency 1 kHz. DFRobot DFR0457
Industrial module with 8 relays. It communicates via RS485 interface and supports Modbus RTU protocol. Waveshare Modbus RTU Relay (EN)
The module is equipped with three 5A / 250VAC relays controlled by digital outputs. Relay contacts are led out to ARK screw terminals. Designed to work with NVIDIA Jetson Nano. Waveshare 3-CH Relay for Jetson Nano
4-channel SSR 240V / 2A relay module with fuse. modSSR-4CH
Module with eight 240V/2A relays controlled by 5V with a fuse triggered by a high state. modSSR-8CH-H