Category: Extension modules for Raspberry Pi
In this category you can find of shield HATfor Raspberry Pi minicomputers. They allow you to add new functionalities to the Raspberry Pi minicomputer, there are communication modules, motor controllers, LCD displays, adapters, modules with sensors and many more.
Subcategories
There are 312 products.
Extension module compatible with Raspberry Pi. The board is equipped with three 24 V 2 A relays, three buffer inputs, three sink outputs and three analog inputs with a working range up to 24 V. Pimoroni PIM213
A pin expander designed to work with the Raspberry Pi. It provides 2 UART and 8 GPIO interfaces and communicates via the I2C bus. SB Components 14873
HAT with 2-channel CAN converter designed for Raspberry Pi minicomputers. The communication was based on the CAN controller MCP2517FD as well as the MCP2562FD transceiver and SPI interface. Waveshare 2-CH CAN FD HAT
3.5" LCD TFT display with touch screen. The display is equipped with an SPI interface for image display and touch screen operation. Resolution 480x320 pixels. Waveshare 3.5inch RPi LCD (C)
Module with environmental sensors for Raspberry Pi. It allows you to measure temperature, humidity, pressure, illuminance, detection of VOC, IR and UV radiation and orientation. Waveshare Environment Sensor HAT
Expansion module designed to work with a portable computer built into the Raspberry Pi 400 keyboard. There are two 40-pin connectors on the board in a vertical position. SB Components 21307
IPS 3.5" LCD display with touch screen. The display is equipped with a DPI interface for image display and I2C interface for a touch panel. Resolution 640x480 pixels. Waveshare 3.5inch DPI LCD
Shield with Qwiic connectors designed for Raspberry Pi minicomputers. It allows you to easily connect the minicomputer with the Qwiic sensor system. SparkFun DEV-15945
2-channel module with relays, designed to work with the Raspberry Pi. It can switch 250VAC/7A or 30VDC/10A signals. SB Components 14088
Module with e-Paper display, 2.13" diagonal and 212x104 px resolution. Communication via SPI interface. Waveshare 2.13inch e-Paper HAT (B)
8-channel module with relays, designed to work with the Raspberry Pi. It can switch 250VAC/7A or 30VDC/10A signals. SB Components 21871
Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini Kit (Adafruit 2327)
Adafruit 2348
Module with barcode and QR scanner designed for Raspberry Pi. It allows you to read one-dimensional and two-dimensional codes using the intelligent image recognition algorithm. SB Components 22595
Audio module with DAC, stereo amplifier and display, designed to work with the Raspberry Pi. Pimoroni PIM484
Extension module dedicated to matrix displays with HUB75 interface. Designed for minicomputers Raspberry Pi. Adafruit 3211
A module with 5 buttons and an RGB diode, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer through the GPIO expander controlled by the I2C interface. Pimoroni PIM301
The expansion module is designed to work with a portable computer built into the Raspberry Pi 400 keyboard. The board has two 40-pin connectors placed in a vertical position and a connector for RPI 400 at an angle of 45 °. Waveshare PI400-GPIO-ADAPTER-C
The audio module with the PCM5100A DAC converter is designed to work with the Raspberry Pi. Pimoroni PIM542
Expansion board with LoRaWAN SX1302 and GNSS L76B dedicated to the Raspberry Pi. The kit includes the 868M antenna, GPS and cables. Waveshare SX1302 868M LoRaWAN Gateway HAT