KAmodTDA2050 - TDA2050 35W audio power amplifier module

Module with the WM8960 audio codec, which allows you to operate 1 W stereo speakers and two microphones via the I2S interface. Waveshare WM8960 Audio HAT

LC filter connected to the output of the DC power supply with a voltage from 0 to 50 V and a maximum current of 2 A. It reduces voltage ripple and interference caused by the power supply

Class-D stereo digital audio amplifier module PAM8403. The system allows you to connect two speakers with an impedance of 4 to 8 Ω and a power of 3 W. DFRobot DFR0119-O

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from a mass memory (flash drive), from a computer via USB or from a microSD card

Pmod I2S2 is a module with 24-bit A / C and D / C audio converters derived from standard 3,5 mm Jack connectors. Thanks to them, it is possible to send and receive stereo audio signals using the I2S protocol. Digilent 410-379

A module with a MEMS microphone and an amplifier that will allow you to detect a voice, a clap or a door slam. The board has an analog output. SparkFun BOB-19389

Class D digital audio amplifier with Bluetooth 5.0 module. It has two channels with a power of 50 W and can work with speakers from 2 to 8 Ω. Powered with DC voltage from 12 to 24 V. Fosi Audio BT20A

The Spectrum Shield enables your Arduino with the capability of splitting a stereo audio input into 7-bands per channel. You can then read the amplitude of each channel using the ADC on your Arduino allowing you to control everything from LEDs to motors, pumps to relays, or even fire, all with sound. DEV-13116

Audio module that allows you to play sounds from a USB memory, microSD card, via Bluetooth or FM radio. It is equipped with a microphone, 3.5 mm audio jack and control buttons

Audio amplifier module with three output channels. It can be powered from 12 to 24 V and has two 50 W outputs (left and right) and one 100 W output (bass). Equipped with Bluetooth 5.0 communication

Digital audio amplifier dedicated to woofers. It has two channels with a power of 50 W each and can work with speakers from 4 to 8 Ω. It is powered with the voltage from 8 to 25 V

LC filter connected to the output of the DC power supply with a voltage from 0 to 25 V and a maximum current of 3 A. It reduces voltage ripple and interference caused by the power supply

Mono audio amplifier module with the TDA7294 chip with a power of up to 100 W. It provides high-quality and effective audio signal amplification and good sound quality. Ideal for audio enthusiasts and professional use

Class D digital audio amplifier with Bluetooth 5.0 module. It has two channels with a power of 50 W and can work with speakers from 4 to 8 Ω. It is powered with the voltage ranging from 9 to 24 V

Recorder v3.0 is a module that allows you to record and play sounds. The module was based on the ISD9160FI system, it also has a FLASH memory with a capacity of 2 MB, which allows for recording up to 83 seconds long. The set contains a small loudspeaker on which recorded sounds can be played. Seeed studio 107020029

The VM-CLAP1 Hand Clap Sensor from Verbal Machines is a low-power, microprocessor-based audio sensor that can detect hand claps or finger snaps while ignoring background noises such as human speech or music. Pololu 2580