Best sellers
There are 15505 products.
WiFi module based on ESP8266. The module has a built-in antenna and USB-UART converter. The module can be programmed in Lua (under the control of the NodeMCU firmware) or in the Arduino environment. 10 GPIO lines are available which each can be configured to work as PWM, I2C.
Pin strip straight in black, double-breasted, female, 2x8, pitch 2.54mm, THT, RoHS. Set of 10 pieces PBD16S
The STM32 Nucleo-64 boards provide an affordable and flexible way for users to try out new concepts and build prototypes with the STM32 microcontrollers, choosing from various combinations of performance, power consumption and features
Panel button, monostable, rectangular, dimensions 16 x 22 mm and SPDT contact configuration
Mini DC motor with permanent magnets with a rotation speed of up to 18,000 rpm. In a housing 130 with a 2 mm shaft
Permanent cylindrical neodymium magnet with a diameter of 7 mm and a height of 1,5 mm. Set of 10 pcs
JST SH type connector, 1.0 mm pitch, surface mounted, vertical spatial orientation. The set includes 10 connectors
The module allows you to attach a strain gauge (working in the Wheatstone bridge circuit) and convert the analog signal into its digital representation, available on the module output lines. The system processes the signal with a 24-bit resolution and can be powered by 2.7V - 5.5V. The module is especially recommended for constructing digital scales in combination with Arduino
A 150mm 2-wire cable terminated on both sides with an XH2.54 plug. 22AWG cable diameter.
ARK terminal connector spring 10-pin, pitch 2.54 mm, non-detachable
Jacek Przepiórkowski
ARK terminal connector spring 5-pin, pitch 3.81 mm, non-detachable
Straight dowel strip with a pitch of 2.54 mm in a 1x3 arrangement. The set contains 10 pieces
2-wire cable, 10 cm long, with a micro 5264 female plug at both ends
The I-1 cable quick connector is an easy-to-use, reliable and durable connector that enables solid connection of electrical wires with a cross-section of 0.5 mm2 without the need for soldering or twisting
The KAmod USB-C Adapter Module allows for the connection of a USB-C port to almost any electronic system. The pin header provides only the essential signals, including 5V power and D+ and D- data lines.
JTAG interface galvanic separator that protects equipment against damage caused by potential differences, with a maximum clock frequency of 110 MHz, 3-5 V power supply, and isolation voltage up to 1 kVDC, equipped with multiple connectors and optical status signaling