Best sellers

Housing for Raspberry Pi 3/2 / B + two-colored (black-transparent). Mounted on screws without the use of glue, made of plastic

QUICK Q-T-3CM minispoon soldering tip for: Quick 236/706/936/3104/3102/TS1100

Real Time Clock Shield for the ODROID-C2/C4

FDC6420C; MOSFET N / P transistor; SSOT-6, Fairchild / On Semiconductor

This small breakout board couples an Electret microphone (100Hz–10kHz) with a 60x mic preamplifier to amplify the sounds of voice, claps, door knocks or any sounds loud enough to be picked up by a microcontroller’s analog-to-digital converter. Each breakout comes fully assembled and works from 2.7V up to 5.5V. BOB-12758

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

RYU002N05, MOSFET transistor, N channel, 0.9V, UMT3

Female terminal block, 2-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-2P. Set of 5 pieces

Female terminal block, 3-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-3P. Set of 5 pieces

IR optical sensor module based on a slotted optocoupler. It enables the construction of an incremental encoder

El-wire is a thin and flexible wire which shines under high voltage. The cord is blue, has a diameter of 3mm and a length of 5 meters

Lipo battery with a capacity of 750 mAh for the M5Stack sets. Modules can be connected in parallel and stacked. M5Stack M002

EL-wire are thin and flexible wires that glow under the influence of high voltage power. Includes battery charger, splitter and five el-wire wires with a length of 1m

The adapter allows you to connect the antenna with the male BNC connector to the device with the MCX socket. The cord has a length of 13cm

DVB-T digital TV tuner for a PC computer, including an internal antenna, remote control and multimedia software. The receiver is based on the RTL2832U system and the 820T2 head, thanks to which it can be program controlled.

The R6 AA battery basket is an essential item for hobbyists, DIY enthusiasts and electronic device users looking for a reliable and easy-to-use solution for powering a single AA battery

Module with a magnetic sensor based on a reed switch. Reacts to the action of an electromagnet or a permanent magnet

Module with a potentiometer with a rotation range of 270 ° with an analog output. Compatible with 3.3 V and 5 V

Compact engine with 75: 1 LP transmission, shaft speed is 290 rpm, torque is 0.8 kg * cm (0.08 Nm), plate with connector PH 2.0. DFRobot FIT0457