Best sellers
There are 15518 products.
Sn99,3Cu0,7 36894 1,00mm/14g solder, produced by Cynel-Unipress, is a lead-free, rosin-based alternative to traditional fillers, meeting ISO 9453:2014 standards and the RoHS directive, ideal for professional and amateur soldering applications
The ring has eight RGB WS2812 diodes, controlled by means of serial signals. The module can be supplied with voltage from the 5V range, only one signal line is required to control it. NeoPixel Ring 8 x WS2812
Module with SSR 240V/2A relay controlled by 5V voltage with fuse. modSSR-1CH
Set of 40 pieces of male-female connection cables, in various colors, 17 cm long. CAB_M-F (Rainbow-40-17)
Module with OLED display, 2.23" diagonal and 128x32 px resolution. Communication via SPI or I2C interface. Waveshare Pico-OLED-2.23
A kit consisting of an M.2 HAT+ module and a Hailo-8L accelerator with a performance of 13 TOPS enables the rapid development of advanced real-time AI applications on the Raspberry Pi 5. This setup allows neural networks for object detection and segmentation to run on the Hailo-8L coprocessor, leaving the Raspberry Pi 5 CPU available for other tasks. The foundation has also prepared rpicam-apps libraries that significantly facilitate the creation of AI projects. Raspberry Pi SC1438
The most popular Sn60Pb40 SW26 solder is a high-quality lead product with SW26 flux, intended for professional soldering in electronics and electrical engineering, meeting the EN ISO 9453:2014 standard
The STMPS2161STR is an enhanced 1-channel power distribution switch. It is designed for applications where high capacitive loads and short circuits are likely to occur.
Tape, in the form of a braid, for removing excess molten solder binder when soldering and desoldering electronic components, 3mm wide and 1.5m long.
Water PCB remover is a product whose main task is to remove residues from the soldering process from various surfaces. AG Termopasty ART.AGT-050
SPDT momentary switch. It enables stable switching between two signal states with a voltage of 250 V AC and 3 A
Digital oscilloscope with compact dimensions. It offers a frequency bandwidth of 200 kHz and a sampling rate of 2.5 MS/s. Equipped with a 2.8" colour display with a resolution of 320x240 pixels. Fnirsi DSO152
XT60E-M connector (male plug) with a maximum conductive current of 60 A. Equipped with mounting holes, it will work as a battery connector or a power connector in RC models. Amass XT60E-M
A universal oscilloscope probe with a BNC connector and a 10:1 voltage divider. It has a frequency response of 200 MHz and allows measurements with a maximum voltage of up to 600 V. Hantek PP-200
A kit to extend the capabilities of the Fingerbot. Contains tips of different lengths and shapes to help adapt the module to different switches and buttons. Adaprox ADFT0101
Angled male socket, cable-to-wire type JST PH, 2-pos., 2mm pitch, 100V, 2A
The MQ-2 sensor allows the measurement of gas concentrations such as propane, butane, methane, LPG as well as alcohol and smoke. Sensor measuring range: up to 10,000 ppm
RS232/RS485-WiFi converter that provides easy communication between the RS232 or RS485 interface and the WiFi wireless network. Supports the Modbus RTU protocol
The MQ-4 sensor allows methane concentration measurement. The measuring range of the sensor reaches up to 10,000 ppm and an analogue signal is obtained at the output.
