New products
New products New products
Best sellers
There are 16641 products.
Development kit with the nRF5340 Bluetooth 5.2 SoC chip, which supports BLE, BT mesh, NFC, Thread and Zigbee protocols. Nordic Semiconductor nRF5340-DK
EXTREME heat shrink tubing for electrical and mechanical insulation, diameter against shrinkage 8.0mm; diameter after shrinkage 4.0 mm, a set of 10 pieces with a length of 1 meter
Module with LSM6DS3 sensor that combines a 3-axis accelerometer and a 3-axis gyroscope. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 105020012
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, Li-Pol battery charging system. Adafruit 3405
A set of 10 cables for connecting Gravity modules to a set with a LattePanda minicomputer. DFRobot FIT0514
The S9V11F5 switching step-up/step-down regulator efficiently produces 5V from input voltages between 2V and 16V. Pololu 2836
IPS LCD display 7" with a resolution of 1024x600 px with a touch panel. It uses the eDP interface and is compatible with LattePanda Alpha and Delta. DFRobot FIT0551
Ambient light sensor placed in a transparent hemisphere. It supports a detection range of 0 to 200 klx and communicates via the I2C interface. DFRobot SEN0390
The board is equipped with ATSAMD21 microcontroller with ARM Cortex-M0 core and SPI Flash memory, GPIO pins and RGB diode. Adafruit 3505
Sound recording module that can store sounds up to 40 minutes long. It allows you to download the recordings to a computer via USB type C. DFRobot DFR0745
Adapter for PS2 (female) connector. The connector is pre-soldered on the PCB. The pins have a 2.54 mm pitch, which facilitates their installation on the breadboard. Cytron Breakout Board PS2 Connector
Vorel cast iron vise for fixing to the table with a clamping screw. Maximum opening: 40 mm. Vorel 36004
Extension module with terminal blocks compatible with Arduino Uno connectors. DFRobot DFR0224
Evaluation board with ATSAMD21 microcontroller with ARM Cortex M0 core. Equipped with motion, temperature, light, sound sensors and RGB diodes. Can be programmed in MakeCode, CircuitPython, Arduino IDE or CS Discoveries. Adafruit 3333
Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012
Evaluation Kit with Bluetooth 5.0 BT401. It is equipped with a microSD slot, microUSB connector and two audio outputs. DFRobot DFR0782
Kit for building an intelligent JetBot robot based on Jetson Nano. It consists of an expansion module, camera with Sony IMX219 image sensor, motors, housing and a set of mounting screws. Waveshare JetBot 2GB AI Kit Acce
The expansion module is designed to work with a portable computer built into the Raspberry Pi 400 keyboard. The board has a 40-pin connector in a vertical position. Waveshare PI400-GPIO-ADAPTER-A
Module with two DRV8830 DC motor drivers. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 105020010
Module with SHT31 temperature and humidity sensor. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020212