Best sellers

Tape, in the form of a braid, for removing excess melted solder when soldering and desoldering electronic components, 1.5 m

USB tester for precise monitoring of the operation of devices connected to the USB port. It has built-in Bluetooth communication. Allows recognition of fast charging modes and monitoring and conversion of PD modes. Fnirsi FNB48S

Adafruit 1171 - Adafruit Small-Size Perma-Proto Raspberry Pi Breadboard PCB Kit

3-port HUB module with USB 2.0 interface and RJ45 connector with PoE function. Designed for Raspberry Pi Zero. Waveshare PoE/ETH/USB HUB HAT

Bluetooth 4.0 BLE module powered with 3.3V voltage based on SOC TI CC2541 (On Chip). The module has a range of up to 10m and communicates via the UART interface.

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0297

Module with an IR receiver. It is equipped with an XH2.54 connector and communicates via a digital interface

Insulation tape company KEMOT in yellow-green 0.13x19 mm with a length of 9.14 meters

Flexible 4-core cable, 200 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17258

A set of 10 men\'s purple male-male cables with a length of 15 cm for contact plates. CAB_M-M (10-15 V)

A set of all sockets and connectors not pre-installed in the Odroid-C0 computer

Module with 4-digit 7-segment LED display. The board is equipped with a TM1637 driver and communicates via a digital interface

A set of colored markers for wires with a cross-section of 2.5 mm². Each tag is labeled with a number for easy identification of the cable bundles. 100 pieces

A set of 10 white male-male white wires, 30 cm long, for contact plates. CAB_M-M (10-30 W)

Kit for building a simple educational robot Maqueen micro:bit chassis with engines, distance sensor, battery basket and necessary assembly elements. DFRobot ROB0148

A small module matching the contact plate based on a 32-bit microcontroller with ARM Cortex M7 core. Has a microSD slot. PJRC TEENSY41

Digital voltmeter with a measuring range from 24 to 500 V AC. Equipped with round 22mm red LED displays

A 2-in-1 device that combines a two-channel digital oscilloscope with a DDS generator. It allows oscilloscope measurements with a bandwidth of up to 180 MHz and the generation of digital signals up to 20 MHz. Fnirsi DPOX180H

Female terminal block, 6-pin. Pitch 3.81mm. Height 11.1mm. 15EDGK-3.81-6P - Set of 5 pieces