

zł24.25 tax excl.
FRAM chip has 64 Kbits (8 KBytes) of storage, interfaces using SPI, and can run at up to 20MHz SPI clock rates. Each byte can be read and written instantaneously (like SRAM) but will keep the memory for 95 years at room temperature. Adafruit 1897
FRAM, or Ferroelectric Ram, is the coolest new data storage method that all the fashion magazines are talking about. Oh wait, no thats quilted handbags. But FRAM is pretty damn cool too! Its similar to Dynamic random-access memory, only with a ferroelectric layer instead of a dielectric layer. This gives it stable handling (the bytes you write are non-volatile) with dynamic responsiveness (you can write them very fast!)
Now, with our SPI FRAM breakout board you can add some FRAM storage to your next DIY project. FRAM allows for a lower power usage and a faster write performance. Its excellent for low-power or inconsistent-power datalogging or data buffering where you want to stream data fast while also keeping the data when theres no power. Unlike Flash or EEPROM theres no pages to worry about. Each byte can be read/written 10,000,000,000,000 times so you dont have to worry too much about wear leveling.
This particular FRAM chip has 64 Kbits (8 KBytes) of storage, interfaces using SPI, and can run at up to 20MHz SPI clock rates. Each byte can be read and written instantaneously (like SRAM) but will keep the memory for 95 years at room temperature.
We picked up the largest chip that has SPI and is also 5V compliant. You can use this chip with either 3V or 5V power and logic. It comes in a breadboard-friendly breakout and a spare stick of 0.1" male header for soldering on.
We also have an I2C FRAM breakout board - which is large in size but slower (1MHz max I2C clock rate)
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
The module with the EEPROM 24LC256 memory chip with a capacity of 32 kB. It is supplied with the voltage ranging from 2.5 V to 5.5 V and communicates via the I2C interface (Gravity connector). DFRobot DFR0117
Module with Flash memory W25Q16 with a capacity of 16 Mbit (2 MB). It communicates via the SPI interface. Adafruit 5635
A module with EEPROM memory with a capacity of 256Kbit (32kB) with the AT24C256 chip in the SMD version. It communicates via the I2C interface
The EEPROM memory module with the built-in AT24C32D chip allows storing data without loss after switching off the power supply. MOD 50
Module with Flash memory W25Q16 with a capacity of 16 Mbit (2 MB). It communicates via the QSPI interface. Adafruit 5632
A small module with Flash memory W25Q65 with a capacity of 64 Mbit (8 MB). It communicates via the SPI interface
Module with Flash memory W25Q128 with a capacity of 128 Mbit (16 MB). It communicates via the SPI interface. Adafruit 5643
2 Kbit (256 B) EEPROM module with AT24C02 chip in SMD version. It communicates via the I2C interface
Module with EEPROM memory, capacity 512 kbit (64kB). Communication takes place via the I2C interface. The module has 3 jumpers that enable selection of one of 8 addresses. SparkFun SPX-14764
Module with Flash memory W25Q64 with a capacity of 64 Mbit (8 MB). It communicates via the SPI interface. Adafruit 5636
W25Q128JV flash memory module with 128 Mbit (16 MB) capacity. It supports communication via SPI, Dual or Quad SPI interface. Waveshare W25QXX DataFlash Board
Module with 512 kbit (64kB) EEPROM. Communication is via the I2C interface. The module has 3 jumpers to select one of 8 addresses. SparkFun COM-18355
I2C FRAM breakout board you can add some FRAM storage to your next DIY project. FRAM allows for a lower power usage and a faster write performance. Adafruit 1895
Module with Flash memory W25Q64 with a capacity of 64 Mbit (8 MB). It communicates via the QSPI interface. Adafruit 5633
No product available!
Module with Flash memory W25Q128 with a capacity of 128 Mbit (16 MB). It communicates via the QSPI interface. Adafruit 5634
Module with EEPROM memory with a capacity of 256 Kbit (32 kB) with the AT24C256 chip in the DIP version. It communicates via the I2C interface
FRAM chip has 64 Kbits (8 KBytes) of storage, interfaces using SPI, and can run at up to 20MHz SPI clock rates. Each byte can be read and written instantaneously (like SRAM) but will keep the memory for 95 years at room temperature. Adafruit 1897