Main view
search
  • Main view
  • Kit view
  • View from top
  • View from bottom
  • Soldered Slider Potentiometer - 10kΩ analog breakout
ID: 1208291
zł13.10
Tax included

zł10.65 tax excl.

Breakout board with a 10kΩ linear slider potentiometer and two independent analog outputs, OUTA and OUTB. It provides smooth manual adjustment and can be connected directly to a microcontroller ADC input. The board measures 86 × 22mm and features M3 mounting holes. Soldered 333130

24h
Available
Available quantity: 2

Description

The device Slider Potentiometer Breakout by Soldered is a slider potentiometer module designed for smooth manual adjustment of values in electronic projects. The onboard 10kΩ linear potentiometer can be used as a control for parameters such as volume, brightness, speed or other values measured by a microcontroller.

The potentiometer provides two independent analog outputs, OUTA and OUTB. Each side can operate independently, while the slider position determines the voltage present at the corresponding output. VCCA, OUTA, GND, OUTB and VCCB connections are available, allowing the output signal to be connected directly to a microcontroller ADC input.

In a typical configuration, VCCA and VCCB are connected to a 5V supply, while GND provides the common ground for both sides. Moving the slider changes the voltage division, producing a continuously variable analog signal on OUTA or OUTB.

The board measures 86 × 22mm, features 1.5mm header pin holes and 3.2mm mounting holes suitable for M3 screws. The mounting hole spacing is LEGO-compatible.

Features

  • Potentiometer
    • Type: linear slider potentiometer
    • Resistance: 10kΩ
    • 2 independent analog outputs: OUTA, OUTB
    • Independent supply connections for sides A and B: VCCA, VCCB
    • Common GND connection
  • Connections
    • VCCA - side A supply
    • OUTA - analog output A
    • GND - common ground
    • OUTB - analog output B
    • VCCB - side B supply
    • Direct connection to a microcontroller ADC input
  • Power and operation
    • Typical VCCA / VCCB supply: 5V
    • Output voltage adjusted by changing the slider position
    • No digital interface - analog output
  • Mechanical parameters
    • Board dimensions: 86 × 22mm
    • Header pin holes: 1.5mm
    • Mounting holes: 3.2mm, suitable for M3 screws
    • LEGO-compatible mounting hole spacing
  • Documentation
    • Arduino library documentation available
    • Pinout diagram available
    • Full product documentation available
    • Getting Started with Arduino guide available
    • Hardware details available
  • Additional information
    • Manufacturer: Soldered Electronics
    • Product code: 333130
1208291

You might also like

Other products in the same category (16)