Soldered Slider Potentiometer - 10k I2C Qwiic breakout

Description

The device Slider Potentiometer Breakout With Qwiic by Soldered is a slider potentiometer module designed for smooth manual adjustment of values in electronic projects. The onboard 10kΩ linear potentiometer can be used as a user-interface control for parameters such as volume, brightness, speed or other values processed by a microcontroller.

The potentiometer provides two independent analog outputs, OUTA and OUTB. Each side can operate independently, while the slider position determines the voltage present at the corresponding output. VCCA, OUTA, GND, OUTB and VCCB connections are available for direct analog operation.

On the Qwiic version, an onboard ATtiny404 reads the potentiometer position and provides the data to the host controller through the I2C bus. The default device address is 0x30, while hardware address switches allow one of eight addresses from 0x30 to 0x37 to be selected. Two Qwiic / easyC / STEMMA QT connectors provide quick solderless connection and allow multiple modules to be chained on the same bus.

The board measures 86 × 22mm, features 1.5mm header pin holes and 3.2mm mounting holes suitable for M3 screws. The mounting hole spacing is LEGO-compatible. Soldered also provides an Arduino library for using the Qwiic version of the module.

Features

• Potentiometer
  • Type: linear slider potentiometer
  • Resistance: 10kΩ
  • 2 independent analog outputs: OUTA, OUTB
  • Independent supply connections for sides A and B: VCCA, VCCB
  • Common GND connection
• Communication and connectors
  • Qwiic version interface: I2C
  • Communication microcontroller: ATtiny404
  • Default I2C address: 0x30
  • Configurable I2C address range: 0x30–0x37
  • Hardware address selection using onboard switches
  • 2 × Qwiic / easyC / STEMMA QT connector
• Analog connections
  • OUTA - analog output A
  • VCCA - side A supply
  • GND - common ground
  • OUTB - analog output B
  • VCCB - side B supply
  • Recommended analog-side supply: 5V
• Software
  • Arduino library available
  • Arduino library documentation available
  • Library used for Qwiic communication
• Mechanical parameters
  • Board dimensions: 86 × 22mm
  • Header pin holes: 1.5mm
  • Mounting holes: 3.2mm, suitable for M3 screws
  • LEGO-compatible mounting hole spacing
• Additional information
  • Pinout diagram available
  • Full product documentation available
  • Hardware details available
  • Manufacturer: Soldered Electronics
  • Product code: 333131