KAmodRPi Pico Prototyping Platform - prototyping system for Raspberry Pi Pico

Description

Prototyping platform designed for use with Raspberry Pi Pico, Pico W and Pico 2 modules, integrating a breadboard and a set of basic input and output components. The layout supports fast development and testing of circuits without repeated manual wiring of fundamental elements, while all GPIO signals are routed to clearly labeled connectors. Built-in peripherals can be disconnected, allowing full reuse of microcontroller pins in custom applications.

The board includes components required for typical embedded system tasks, such as push buttons, LEDs, addressable WS2812 RGB LEDs and a piezoelectric buzzer for sound generation. The analog section consists of a potentiometer with a range of 0 - 3.3 V and a photoresistor, enabling ADC testing and simulation of sensor signals. The I2C interface is available on a Qwire connector, enabling fast connection of external modules compatible with Qwiic and STEMMA QT standards.

Power is supplied from 5 V via the Raspberry Pi Pico USB port. The board includes status LEDs for power rails and polymer fuses protecting supply lines against overload and short circuit. A dedicated RESET button connected to the RUN pin enables quick restart of the program without disconnecting power, and the datasheet includes an example test program with source code for LED control.

Features

• Product for Raspberry Pi Pico, Pico W, Pico 2
• Female header: 2 x 20 pin, 2.54 mm pitch
• GPIO breakout on 2.54 mm pin headers
• I2C Qwire connector: JST SH 4-pin 1 mm compatible with Qwiic and STEMMA QT
• Breadboard: 400 tie points
• LEDs: 4 red
• LEDs: 8 addressable WS2812
• Buttons: 4 momentary
• Analog potentiometer: 0 - 3.3 V
• Photoresistor for light sensing
• Piezoelectric buzzer
• RESET button connected to RUN pin
• Detachable onboard peripherals
• Power indication LEDs: PWR, 5V, 3.3 V
• Supply voltage: 5 V
• Protection: polymer fuses
• Dimensions: 85 x 140 mm

Kit includes

• 1 x assembled and ready-to-use KAmodRPi Pico Prototyping Platform module
• 6 x rubber feet for stable placement on a work surface
• 1 x 400-point breadboard with dimensions 82 x 55 x 10 mm with double-sided adhesive tape
• 40 x female-to-female jumper wires, 17 cm length, various colors
• 1 x 1 x 40 pin male-to-male goldpin header, symmetrical, for breadboard connections